20 Most Recent
2005 Kymco People S 200 - Page 2 Questions & Answers
Relpace a transmision belt at agilty 125 kymco
you have to figure out how to remove the side body panels first.i just examined mine,starting taking off a few screws at a time.it does take quite a tug to undo the panel from the clips.the back 3 clips you had to slide toward the back to unseat,but first to unseat the front 2 i had to pull straight out.that should give you enough access to the chain case.REMEMBER PULL THE PANEL A LITTLE HARD BUT BE CAREFUL,THEY LOOK LIKE THEY COULD BREAK.cheap a$$ foreign ****.
Change brake lever
"4 phillips head screw on the bottom, loosen it and the lever will come off
HOW TO GET THE BACK WHEEL OFF
Please check your owner's manual. (Seems like the rear springs are bolted together to the rear tire. In that case, you will have to remove the axle bolts and knock it out with a rubber mallet).
Hooked battery up wrong, speedometer not working
You are very lucky to have only knocked out the speedometer only. After having wrongly connected the battery, any attempt to start the engine, which it won't be able to do, the first notch turned by the key switches on the electrically operated instruments. Since this is DC voltage, the current flows in only one direction. The speed is indicated by the amount of current being generated in the potentiometer. Since the polarity got changed the current generated by the potentiometer to very high amperage since the battery is also supplying current(polarity change), the total current is much more that it can accept. Thus the coils of the potentiometer have burnt out. If only the can be replaced, do so, else change the entire speedometer assembly.........sodeep
PS: Ask the repairman to check the fuse if it has one.
Dead battery
Steve when you store a vehicle it is best to use a trickle charger to maintain the battery.
Buckyrain, I believe your problem can be solved by replacing the charging fuse next to the battery. It is not with the other fuses. If you pull the battery out it should be on the left with a plastic cover thing over it. Follow the power line and it will be along that.
Changing the speedometer cable
Assuming it's the same as my Kymco Agility, it's really easy cheapest is to buy a new one on ebay, it connects under the right handlebar to the throttle, there's a clip under the handle clip it in rescrew on the throttle handlebar and feed it through to the carb, just feed it through where the old one went and connect it to the top of the carb and that's it.
De-restrict
It`s ALREADY de-restricted!!! Restriction is only for keeping the 50cc models in the Moped category so some people whould not need an endorsement and not exceed 30mph,
Oil change
you find the drain bolt under it and take it out and drain the oil put the bolt back in and refill.
Not getting fire
check your fuses as well as connections to your coil check your on off switch for power. use a test light for these tests it has to be electrical source related
My scooter was parked for
The carburetor is gummed up a bit from petrol evaporating over the past year. Remove the carb and then the float bowl on the bottom of the carb and then clean the carb with spray carb cleaner. Pay extra attention to the float needle area. A generic diagram is below. Please rate my answer. Thanks.
Bike wont start but turns
The battery may be drained. This is both true for kick start and those with a starter motor. See if you can jump start the bike when you push it and put it in gear. If it starts it is a battery issue.
It needs to be rethreated
You can buy a thread tap at most any good auto parts store or hardware / tool store. The tap will re-thread the existing threads. Bear in mind that if the hole has been stripped out really bad, the integrity of the re-thread is questionable. Having a local machine shop do the re-tap is advised. Alternate to that is just buying a new cylinder head.
Please rate my answer. Thanks!
Broke piston ring
Wneh you fit new rings be sure to scour the cylinder bore with a rotary wire brush in the chuck of an electric drill, otherwise the rings won't seat correctly and it may burn oil and lose compression.
Treat as a new engine and run the rings in.
It will not start by
When you kick start a motorcycle or scooter, the motor turns over much faster than your electric starter can turn it over, even with a new battery.
I saw this before with several brands of scooters and the problem was solved by making sure you have clean battery terminals, and a fully charged good battery.
Some batteries will take a full charge but cant take a load. So your battery may seem good because it has 12+ volts, but when you try to start it it drops below 10-11 volts.
Most local auto parts stores can put a load test on your battery for free. If you purchase a new one, make sure it is the one called for for your scooter.
The ZX-50 suddenly won't accellerate
There are only three things that could do this:
1. Air intake restriction
2. Fuel restriction.
3. Throttle cable slippage.
Please check the filters, the throttle cables etc.
Not finding what you are looking for?