20 Most Recent
2007 Aprilia Sportcity 250 Questions & Answers
What is 6k maintenance?
6K-Service
Preventive Maintenance
- 15 Point Check
- Change Engine Oil
- Replace Oil Filter
- Top Off Fluid Levels
- Lube Chassis
- Adjust Tire Pressure
- Check Spare if accessable
- Rotate Tires *
Wont start
You don't mention whether the engine is turning or not. If the starter is going, but the motor not turning, the starter clutch is gone. If the motor is turning, then it's a fuel or electrical problem. Try this -- take out the spark plug.Try this in the shade of a dark corner of a garage. With it still connected to the lead, hold the base of the plug against the engine while you activate the starter.If you see a spark, the electrics are is good. Shining a flashlight in the spark plug hole will show you if the piston is going up and down or not. If not, get the starter clutch replaced.
How do i reset the service spanner symbol on my
Ok, disconnecting the battery does NOT reset the service light. To reset the service light (spanner symbol) on dashboard you must hold the mode button for about 5 seconds with ignition OFF then while still holding the mode button turn ignition on, continue holding the mode button for a futher 10 - 12 secs and then it should just disapear. This solution was brought to by RPMs. Mobile motorcycle service.
How do you reset the service warning light on a
Hi,
When the vehicle is started and right after the ignition check, if there are less than 300 km (200 mi) left
to the next Service, the specific icon flashes for 5 seconds. Once the service mileage has been reached,
the icon remains steadily until the Service is reset.
The warning light can be zero set even if the mileage is lower, up to 300 km (200 mi), compared with
the Service mileage. During the 300 km (200 mi) before the service warning light comes on, the light
flashes 5 times each time the key is set to ''ON''.
The light should turn on first at 1000 km (625 mi). Successive times are strictly at 10000 km (6215 mi)
20000 km (12430 mi), etc
RESET
Hold the MODE button down.
Turn the key to ''ON'' and wait 10 seconds.
During this operation the service icon flashes.
Good luck,
Alex
PS-Don't forget to vote me, thanks!
My aprila rs50 starts fine and runs fine cold but if it heats up abit you pull the throttle and it sounds like its dieng
Instructions
-
-
1
Park your RSV 1000R on a well-ventilated, level area, using its kickstand.
-
2
Start the engine and let it idle in place until the
temperature gauge built into the instrument cluster indicates a minimum
internal temperature of 180 degrees Fahrenheit. This is the motorcycle's
ideal operating temperature.
-
3
Take note of the engine idle speed, using the tachometer
needle, while the engine is running. Ideally, the engine should idle
steadily at 1,250 rpm.
-
4
Adjust the engine idle speed to 1,250 rpm, using the idle
adjuster screw hidden between the lower right edge of the fuel tank and
the upper edge of the right middle fairing panel. Turn the idle adjuster
screw clockwise to increase the engine idle speed, or counterclockwise
to decrease the engine idle speed, using a small flat screwdriver if
your RSV 1000R's frame (VIN number) precedes ZD4MEE009YS000292. A
plastic knob allows the engine idle speed to adjusted by hand on RSV
1000R models with a frame (VIN) numbers starting from ZD4MEE009YS000293.
-
5
Rev the engine two to three times and observe the
tachometer. The engine should return to a 1,250 rpm idle. Adjust the
engine idle speed as needed, using the method described, then rev the
engine again. Problems may exist within the throttle control,
fuel-injection system or engine, if the engine idle speed will not hold
steady at 1,250 rpm. Contact your local Aprilia service facility for
assistance.
-
6
Stop the engine, once you have obtained a steady 1,250 rpm idle speed.
5/20/2022 6:46:22 AM •
Aprilia...
•
Answered
on May 20, 2022
Not finding what you are looking for?