20 Most Recent 2001 Harley Davidson FLHR - FLHRCI Road king - Page 5 Questions & Answers


Hi, Marc the vast majority of speedometer issues is caused by the speed sensor and or the wiring. On Sportsters the sensor is located on top of the engine case behind the rear cylinder, on big twins it's located on the right side of the transmission case between the starter end cap and the transmission top cover. Remove the bolt/screw that secures the sensor and lift the sensor out of the case. Inspect it for damage and contamination, if there appears to be no damage wipe the end of the sensor clean and reinstall, you can go for a short quick test ride to see if the speedo is working. If the issue still exists grab your test light and unplug the harness connector from the sensor, check for power (red wire) and ground (black wire) continuity coming from the speedo, there is also the connector that plugs into the speedometer, also look for corroded, broken or loose pin/sockets. If everything checks out OK then replace the speed sensor. For more information about your issue, please visit the websites below, and for specific information or questions, please feel free to contact me at xlch@mail.com. Good luck and have a nice day. Harley Davidson Manuals Mark Workshop

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on Oct 23, 2015


Hi Anonymous, call, take a ride or trailer your bike over to your local dealers service/parts department, I'm sure they will be happy to take your Harley Davidson for a test ride if necessary/possible and offer professional advice and assistance concerning your issue. Good luck have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on Jun 29, 2015


Hi P_o_box55, for more information on your question please visit the websites below and good luck:
Harley Diagnostic Codes 04 to Present

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Tomsthts01, for more information on your question please visit the websites below and good luck:
Adjust or Tighten Harley Road King motorcycle Handlebar

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Harley Davidson... | Answered on May 29, 2015


Hi Wkcasas, for more information on your question please visit the websites below and good luck:
http://img.jpcycles.com/staticwebfiles/instructions/pdf/700-485.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Angelbearinc, and the usual suspects are:
1. Severely discharged or damaged battery.
2. Loose, corroded or broken battery cable.
3. Alternator not charging or below normal rates.
4. Failed ignition coil, ignition/electronic module.
5. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor.
6. Faulty ignition switch.
7. Water or dirt in fuel system, carburetor or filter.
8. Fuel tank vent system plugged or gas cap not venting.
9. Fuel tank empty.
10. Fuel valve vacuum line broken or carburator vent line closed off.
11. Restricted, blocked or kinked fuel line.
12. Failed fuel pump, pressure regulator and or fuel injectors.
For a prime suspect please visit website below and good luck:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Anonymous, take a ride over to your local dealers service department I'm sure they will be happy to offer advice and assistance concerning your issue. Have a nice day

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Anonymous, for a free wiring diagram please visit the website below and good luck.
Harley Davidson Wiring Diagrams and Schematics

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Don, for more information on your question please visit the websites below and good luck:
How to Replace Install Inspect Brake Pads on Harley Davidson Guide...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Harley Davidson... | Answered on May 29, 2015


Hi Anonymous, for more information on your question please visit the websites below and good luck:
Rinehart Baffle Removal Harley Davidson Forums
How to Remove Rinehart Baffles eHow
question about baffles for Rinehart exhaust Twin Forum Harley...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Rick, always check fuses and bulbs first for broken filaments. Then check the connection at the rear fender wiring harness, inspect for corroded, broken or loose pins. Use a dab of dielectric grease and repair as necessary. Check your brake relay if you have one , check your brake light switches for continuity, some models rear turn signals were single filament bulbs only, no running light. If all else fails get out your test light and start tracking the power wire from the harness connection. For a free wiring diagram please visit the website below and good luck:
Harley Davidson Wiring Diagrams and Schematics

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 29, 2015


Hi Anonymous, 32 oz. Primary Chaincase Lubricant. Have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Anonymous, on top of the intake manifold/induction module.
Have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Finnegantrae, for more information on your question please visit the websites below and good luck:
Cycles Capacities and Fluid Requirements Fork Filling Quantities

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Anonymous, for more information on your question please visit the websites below and good luck:
Harley Davidson Road King 1999

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals,
ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust vale.
For a prime suspect please visit website below and good luck:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Edwin, and the usual suspects are:
1. Severely discharged or damaged battery.
2. Loose, corroded or broken battery cable.
3. Alternator not charging or below normal rates.
4. Failed ignition coil, ignition/electronic module.
5. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor.
6. Faulty ignition switch.
7. Water or dirt in fuel system, carburetor or filter.
8. Fuel tank vent system plugged or gas cap not venting.
9. Fuel tank empty.
10. Fuel valve vacuum line broken or carburator vent line closed off.
11. Restricted, blocked or kinked fuel line.
12. Failed fuel pump, pressure regulator and or fuel injectors.
For a prime suspect please visit website below and good luck:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi William, yes. Have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015


Hi Anonymous,
1. Front axle nut 50-55 ft lbs.
2. Front fork cap nuts 11-15 ft lbs.
3. Rear axle nut 60-65 ft lbs.
Have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Harley Davidson... | Answered on May 26, 2015

Not finding what you are looking for?
2001 Harley Davidson FLHR - FLHRCI Road king Logo

79 questions posted

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5962 Answers

Mike

Level 3 Expert

4363 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

FLHR - FLHRCI Road king Harley Davidson

  • FLHR - FLHRCI Road king Harley Davidson

Most Popular Question

two things first tyre pressures

  • Motorcycles
Loading...