20 Most Recent
2005 Harley Davidson FLSTN- FLSTNI Softail Deluxe - Page 9 Questions & Answers
How to reset clock on 2010 softail deluxe?
Turn the ignition switch to ACC or IGNITION, press the function switch until time (hour and minutes) is displayed. Press and hold the function switch for five seconds or until 12HR begins to blink in the speedometer display window. Then release the button. THEN press and release the function switch once to advance to a blinking 24HR or military style time display. Then each time you press and release the switch, the display will change from 12HR and 24HR. When the desired time is displayed, press and hold the function switch for five seconds and the display will switch to the time display with the hours blinking. There is NO AM/PM setting. Press and release the function switch repeatedly to advance the hours to the hour you want. It will advance by one hour with each press of the switch. WHEN the desired hour is displayed press and hold the function switch for five seconds and the minutes display will appear and blink. THEN press the function switch repeatedly until the desired minutes display is attained (the minutes value will change by one minute for each switch depression) and then press and hold the function switch for five seconds and the minutes display will stop blinking which indicates that the time has been set. Turn the ignition switch off and the time you set has been saved and will change as time passes.
Do you oil the air filter on a 05 harley softail deluxe
You only oil it if it is the oil-able type and you have washed it and dried it properlyu and then you use a filter spray oil and sparay enough oil on it to cover the surface but not so much thatit will drip off when in service.
Location fuel filter replace
What YEAR are you talking about??????
As in, is it a CARB, or FUEL INJECTION????
Two TOTALLY DIFFERENT fuel filters AND locations!!!!!!!!!!
Fitting exhaust
Most exhausts can be changed without altering the intake side. It is when you make changes to both intake and exhaust that settings need to change due to increased air flow.
What is the spark plug
Hello Peter, shop manual shows .038 to .043
... If you buy the plugs from Harley, they will be pre-gapped at .040 ---As a rule ALWAYS double check the gap, just in case they were altered during shipping. It only takes a minute & it could save you from having to remove them.
I hope this helps.
My primary casing is very
The primary case will get hot as there are moving parts inside and it is directly connected to the engine. Check the oil level in your primary. Since you didn't tell me what year and model bike you have, stand the bike straight up. If it's a Big Twin, remove the round derby cover from the back end of the primary and look at the oil level inside. It should be just up to the bottom edge of the clutch outer drum. In the case of a Sportster, simply drain the primary by removing the drain plug under the lower backside of the primary. Remove the small round inspection cover at the top side of the primary cover and add one quart of oil.
Good Luck
Steve
Not finding what you are looking for?