20 Most Recent
2008 Harley Davidson VRSCDX Night Rod Special Questions & Answers
How to change steering head bearings
If bearing races are removed, the bearings cannot be reused, they must be replaced.
1. Support motorcycle so front end is off floor and forks are fully extended.
2. Remove right side cover and remove maxi-fuse.
3. Remove headlamp and headlamp bracket.
4. Remove both front brake calipers.
5. Remove front wheel.
6. Remove front fender bracket with front fender.
7. Loosen but do not remove fork tube caps.
8. Loosen all pinch bolts on top and bottom triple clamps and pull fork tubes from triple clamps.
9. Remove brake hose bracket from the bottom of fork stem and bracket.
10. Remove fork stem cap and remove fork stem nut.
11. Lift handlebars from steering head with upper triple clamp attached. Be careful not to pinch or kink control cables.
12. Remove adjusting nut, seal, and upper bearing out of bearing race.
13. Pull fork stem and lower triple clamp from bottom of steering head.
Not finding what you are looking for?