20 Most Recent 1986 Honda CBX 750 F Questions & Answers

0helpful
1answer

I have a 86 honda roadhawk motorcycle and the

check all your negative cables are secure as well as the grounding of the batery
3/24/2010 8:48:51 PM • 1986 Honda CBX... • Answered on Mar 24, 2010
0helpful
1answer

There is a noise in the engine and i have fond on

dynamo chain?

I am going to interperate this to be a motorcycle alternator reference.

Honda motorcycle engines I am familiar with (USA market) have the alternator attached directly to the crank shaft, and do not drive anything else.

There may be a overhead cam chain in your engine and I can tell you they will make noise, particularly as they age. You claim your motorcycle is more than 20 years old. It probably shows some wear and it can probably be adjusted.

Please visit the Honda site at http://hrca.honda.com/ At this site, they offer free access to generic engine manuals. If you pay the few $ to join, you can get your manual free to download according to information posted at the site.

I hope this helps you resolve your question

Thanks for your interest in FixYa.com

please vote

thanks

a
12/12/2009 11:20:43 PM • 1986 Honda CBX... • Answered on Dec 12, 2009
0helpful
1answer
0helpful
1answer

I Have a CBX Honda

Check carb balance as this can cause primary drive gear lash as these are straight cut gears
11/9/2014 11:13:14 PM • Honda CBX 750 F... • Answered on Nov 09, 2014
0helpful
1answer

How do i replace the headlight bulbs in my 86 CBX750F2

Hi While it is possible, with skinny super flex hands to change them in situ, For most of us you need to take the front fairing off, unbolt the 3 holding bolts for the head light and reamove the rubber caps. and plugs, remove the spring retainers and replace bulbs.This is a long winded process but saves a lot of skin.
9/27/2014 1:13:09 AM • Honda CBX 750 F... • Answered on Sep 27, 2014
0helpful
1answer

Can a kickstarter be installed on 1984 cbx750 f?

If you mean a CB750, then the answer is no. This bike was made without a kick starter and there is no opening in the cases to fit one.
9/10/2014 10:25:51 PM • Honda CBX 750 F... • Answered on Sep 10, 2014
0helpful
1answer

My honda wont start

Take out the plugs and lay b the subframe or earth part if there is spartk maybe fuel or filters u may need to flush the system out or it could be old fuel it would be worth adding a inline fuel filter
6/29/2014 4:45:43 PM • Honda CBX 750 F... • Answered on Jun 29, 2014
0helpful
1answer

Hard to start then runs

you dont say what model your bike is, but on a quick one it sounds as if your ignition timing is out, or you have a faulty coil .
9/3/2011 10:49:27 AM • Honda CBX 750 F... • Answered on Sep 03, 2011
0helpful
1answer

How to remove seat from

tilt seat using button near grab rail then remove 2 pins. off
4/29/2011 1:44:01 PM • Honda CBX 750 F... • Answered on Apr 29, 2011
0helpful
1answer

Were are the fuses on

In the past Honda has used behind the head light for the wire junction, that's where I found a broken wire for mine
3/10/2011 12:46:13 PM • Honda CBX 750 F... • Answered on Mar 10, 2011
0helpful
1answer

Looking for a set of

Dpautomotive should be able to help.
http://www.dpautomotive.co.uk/?gclid=CNvVmvG5m6cCFcULfAod3FR-cg


Hope that helps.
2/22/2011 9:30:42 AM • Honda CBX 750 F... • Answered on Feb 22, 2011
0helpful
1answer

Starter is turning but engine

Pull the starter and see if a gear on the starter is properly turning on the starter moter shaft
10/5/2010 9:16:29 PM • Honda CBX 750 F... • Answered on Oct 05, 2010
0helpful
1answer

Hi there. i seem to

In your slave cylinder is a piston o-ring that seals the system. The o-ring sits in a groove. In the groove underneath the o-ring is some corrosion. Fluid is not leaking out but air is leaking in. If you take the slave apart and clean out the corrosion in the groove , may as well put in new seals, reassemble , and bleed the system, you should have the problem solved.
9/22/2010 2:55:24 PM • Honda CBX 750 F... • Answered on Sep 22, 2010
0helpful
1answer

I have a 78 honda it has been sitting, won't idle

The stock pilot screw setting is one and one half turns. The usual problem for not idling is that the slow speed circuits in the carbs are still plugged up. Secondary cause is usually that the carbs are not in sync > The carb slides don't all move upward at exactly the same moment. If you haven't installed new spark plugs, do it. Soak the carbs in denatured alcohol after removing the slides and float bowls. Finish with spray carb cleaner and compressed air. Spray into all the drill holes, ( circuits ), in each carb. Install an in-line fuel filter to prevent trash from the gas tank getting into the carbs.
7/4/2010 9:11:17 PM • Honda CBX 750 F... • Answered on Jul 04, 2010
0helpful
1answer

I have a1975 cb750 4 honda i have not driven it in

a good site on just that ,

http://www.cyclemaintenance.com/mechicscorner/cb750_carbs.htm

good luck
1/23/2010 9:43:34 PM • Honda CBX 750 F... • Answered on Jan 23, 2010
0helpful
1answer

Cbx 750.Can you fix the

You can't fix them but you can replace it.
Stator, CDI Box, Regulator, Rectifier and Pickup Pulsar Coil
11/12/2009 11:12:28 PM • Honda CBX 750 F... • Answered on Nov 12, 2009
0helpful
1answer

The neutal light does not go out, when in gear.

take it out & clean it as it may just be stuck!
8/11/2009 11:47:56 AM • Honda CBX 750 F... • Answered on Aug 11, 2009
0helpful
2answers

Honda 500 TRX fa6 has PS on the dash….what does it mean ?

The Power Steering has failed. There has been a factory recall for a suddenly failing electrical steering shaft, that could cause the rider to loose control. This does not have to be your problem but anyhow either the electronics or the pump failed. Error codes or messages usually have to be erased by a simple reset procedure or disconnecting a plug, after repairs are done.
3/31/2024 4:25:47 AM • Honda... • Answered on Mar 31, 2024
0helpful
1answer

1985 Honda Gold Wing 1200. How can I get my clutch to release? It is so hard. Put a new master cylinder on it and pumped up. It is so hard and they've even bled it. How can I get it to release?

Question edited for clarity, but no idea what you mean by - "What do I need to do to get the gay? The clutching gauge in again?" You issue is probably that all the clutch plates are glued together. Leaving a bike for 21 years will do that. https://www.google.com/search?q=1985+Honda+Gold+Wing+1200+stuck+clutch ..
2/27/2024 6:46:12 AM • Honda... • Answered on Feb 27, 2024
Not finding what you are looking for?
1986 Honda CBX 750 F Logo

5 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

CBX 750 F Honda

  • CBX 750 F Honda

Most Popular Question

86 honda roadhawk motorcycle

  • Motorcycles
Loading...