Top 20
1993 Honda CBR 900 RR Fireblade Questions & Answers
I have a 96 blade,starts
It must not be charging, probably need to check the generator and the battery. It might be time to replace them both.
Bike was running fine all
your battery is dead you can recharge it with a 12 volt battery charger. you could also jump the bike with another bike or a car. if these two solutions aren't possible because you don't have the necessary equipment or whatever you can bump start the bike by pushing it (works best down hill and/or with buddy's help) hoping on with the key in the on position and shifting into 2nd gear and dropping the clutch. be careful and goodluck
As soon as i put it in gear it dies
will the bike start while you have it in gear and hold in the clutch and "kickstand switch" up position.? can i get a four thumbs up if this gets you in the ball park. thanks.
How do i check a stator on my motorcycle?
Get yourself a multimeter, On the side of the motor you will have wires coming out, follow it the plug, unplug it. you'll need to set your meter to the ohm setting. you'll have three wires of the same color ( yellow or white) check and see if any of the three wires are grounded if so bad stator. if not, set your meter to ac and check the ac out put of the stator. if you getting ac out put your reg/rec. is most likely bad.
Hope this helps and good luck.
Mark
C.C. Motorsports
Does anyone know about fuses. I have a 1993
sorry that didnt help...i found my 30amp fuse connected right into the starter relay...the fuses look just like the usual ones....on my old 87 cbr it is located under right hand cover..close or near to battery housing...follow the red wire to see where it runs off to. On my bike the fist thing it runs into is the starter relay with a nice big 30ampere fuse on it....i havent worked to see if their are others because i went through my print and thats seems to be it. Can you describe your exact starting propblem...i my be able to suggest a few things....need recent maintenance reports! later and hope to get it running.
How much oil I have to put inside the engine??
Most 900-1000cc sport bikes require 3.8 qts
depending if you are also changing the oil filter or not (which I would recommend
also if you do buy the filter pay the extra few $ for the Honda oil filter
wrench that comes with the filter, it makes the allot easier and also works on
all Honda models as well as most other model bikes with that style oil
filter...but remember only a quarter turn past hand tight or so should do the
trick, you don’t need to go crazy)...If you are not changing the filter it will
take a little less...most likely around 3 qts depending oh how much is trapped
in the oil filter sill
Buy 4 quarts. Put 3 in and run the bike for
about a min or two at idle to let the oil circulate as well as heat up and
expand. Then shut the bike off and let it sit for another 5 min, then if needed
have a friend hold the bike upright or do it yourself if your confident (but don’t
him or sit with weight on the seat or bike or it will affect ride height and in
turn oil level)
Then add oil as needed, to fill it to just under
the top of the 2 oil marks (leaving a little room for the still cool oil to
expand)
Then make sure everything is clean and your oil drain bolt is tight and
take it for a small 5 min test ride...then check the oil again.... and you
should be just where you want it
On off throtle driveability problems over 5-6000
I had the same problems w/ CBR. I replaced the plugs, fuel pump, and rebuild the carbs. Solved it. Each one of these things can cause the issue you are having, and it being a 93 model, chances are it is time to do all of this.
This should take care of it man.
What is the Procedure of Hp 123 Com Setup
To set up an HP printer with a PC or adaptable phone, you charge a affairs through with the machines can communicate. Nonetheless, the cast has advised altered software/ app for altered devices 123 hp com setup. Thus if you would install a software disciplinarian on an adaptable phone, it will not work. On the contrary, installing the appropriate affairs will accord you a smoother experience.
Hi
I recently jump-started my bike
Might try removing or disconnecting the alarm to see if you have tripped an anti-theft circuit on the bike. If you have then you'll need to refer to your owner manual or local Honda dealer.
If the bike works fine without the alarm then I would reset the alarm. I found the manual on Google pretty quickly
Will the fairing and tank from a 1996 fireblade fit a 1994 fireblade?
There was a facelift model in 1996 so the fairings are slightly at the front as different as Honda came up with the fox/tiger eye headlights.
Other than that, they look very similar including the tank. The support bracket which holds the top fairing on might be different.
If you're buying these parts off the internet, I'd contact your local Honda dealer first as you could be stuck with these parts if they don't fit.
Side stand switch
About the only way I can think of to clean the switch is spray it with electrical contact cleaner (auto parts store)
Knocking on engine
Sounds like it's spun a bearing
Not an easy fix motor out and strip down to remove crank.
and change bearings?
unless you know what your doing Should go to shop?
Good luck.......
Not finding what you are looking for?