20 Most Recent 1999 Honda VT 1100 C Shadow Spirit Questions & Answers

For stick on decals try using hot soapy water and a lot of care .don't pull too hard as you may take of paint with the decal once you have poured the hot soapy water over the decal ,try and get the edge of the decal to come away from the tank .start with your thumb nail Never use any abrasive tool like a knife or screwdriver as this will scratch the paintwork.and once you have a finger grip pour hot water on the decal directly where its attached to the tank .The hot water softens the glue on the decal .pull very gently .it does help tp have another person pouring the water on the decal ,this will leave your hands free to remove the decal.Once decal has been removed ,try using a small amount of petrol on a rag or a good colour restorer polish .to remove the glue left on the tank .Depending how long the decal has been on the tank ,you may well find that the sun has bleached the tank from it original colour .and the paint under the decal will be much fresher looking and of a deeper colour.

could be several things 1-- coolant radiator is partially blocked or the thermostat is not fully opening reducing the flow of coolant through the radiator 2--- tuning is too lean at full load which causes overheat conditions for the engine 3--- timing a bit retarded for the rpms i t is all connected to the extra load from the head winds requiring extra throttle that you would not normally use in normal conditions another place to check is the fairing in use as the extra wind speed from the bike and the head wind may be causing a turbulence around the radiator and so preventing full air flow to the radiator

Yes, the starter is bad (brushes 2 or 4 are worn), but you can fix it, unscrew 2 starter bolts (on the right side of starter) push the starter to the right using flat screwdriver, take it out and open it gently, you will see warn brushes (they slide on rotors surface, check that too, it should be flat and smooth. Buy brushes on ebay. Here is some help from youtube: https://www.youtube.com/watch?v=9EHQJDhxZc0

I think it is the fuse, it is not the same for the horn

First try to sync the carbs (link 1), if you can not balance them, then you have to rejet the slow and main jet. Do not drive the bike without sync the carbs, overheating can destroy cylinder, rings, cam chain etc. link1- https://www.youtube.com/watch?v=Ulsw0235OKY

it will always POP,, because you have no more back pressure and hot exhaust gases come out quicker and burn in your exhaust pipe.

no the petcock is vacuum operated and shuts off fuel if the engine is not running (while petcock is in RES or RUN positions

ok we need more info on it .... is the battery charged? is the key turning over? or do you hear just clicking? paint a picture of what the bike is doing....

float heights are not usually needed to be adjusted, the float valve will have a rubber tip, so it wont wear and change the float height. if flooding is a problem, new float valves may be necessary, but more likely the fuel tap needs a kit

Please check the carb and clean the jet and various nozzles as it seems that there is not enough fuel reaching the engine. May be the fuel filter is clogged. If so, then it needs replacement. Do that.

Hi,
The air is trapped on your brakes system . Please release them first then.
Regards

Check the fuel system, see if you have a clogged filter or sock (behind the pet-****). You can also check the plugs too. They should be around 7k OHMS. Either your loosing spark or fuel.