20 Most Recent
2000 Honda XR 250 R Questions & Answers
Carby
Remove carb. Remove fuel bowl to access jets. Low speed jet is separate off to one side. Main jet is in center and threads into emulsion tube which has metering needle down its center. Unscrew main jet from emulsion tube and replace with bigger or smaller (depending on your desires).
XR 100 didnt move for a year.My bad so i cleaned
First Make sure you have all new fresh gas,and new fuel filter,Then check the intake tube between the head and carb for cracks or leaks,And You'll need to go back through the carb again as this is a carb issue,But without doing the above first,a clean carb won't be clean for long.
2006 Honda XR250, How many Km should I change the oil?
depends if your doing a lot of short outings etc ! ? if the oil is black then change it , do 100km after oil change and check condition ! mite take a few oil changes to get clean unless your up to stripping the engine and clean everything !? if using for competition then its different again , change after each meeting as harder work out and need to keep quality of oil to max ! also the piston and rings are changed after every meeting , try and get the xr manuel as its got the periods of replacements etc !
Chat dirt bike problems
Could be coil or kill switch... check spark plug wire and contact by pulling off and checking if it will arc when held within 1/4" from a metal part close enough to reach... do this when dark so u can see the arc if and when it happens... if no arc then replace wire, then coil...
Good luck
Only stays cranked on full choke.
your carb. is gummed up. Get some carbeurator cleaner spray and spray it into the air intake as it is running until it clears up. if it wont clear up, you will have to have the carb rebuilt.
How do i remove the
Hi There.
There is no bearing in the forks. you are trying to take aparts the triple trees.
to remove the front forks
jack bike up
remove front wheel
remove fender
loosen the clamps that go around the forks.
there are 2 triple trees, upper and lower , the upper has the nut your taking off, of course the lower is the bottom. both have clamps that hold the forks in.
then just pull and twist in a downward motion to get the forks out.
reinstallation is reverse steps.
note how much fork is sticking up through the hole in the top triple prior to removal.
if you do want to remove the triple trees and replace your neck bearings, you will have to cut the bottom bearing off, i've never been able to remove those bearings without ruiing them.
that bearing is a very tight fit.
Hope this helps you out.
thumbs up to the do-it-yourselfers
Best regards
Big Al
Is the engine 2 stroke
Honda engines are traditionally 4 stroke. If the exhaust comes out of the head it is a 4 stroke, if the exhaust comes out of the cylinder it is a two stroke.
Not finding what you are looking for?