20 Most Recent 2002 Honda CR 125 R - Page 2 Questions & Answers

pull the clutch plates back out and reassemble in the correct order and sequence best get a workshop manual to see how to do it and how to adjust when finished

It gets clogged up very easily. get it cleaned out.

The hole that your coolant is leaking from is a vent hole. Its purpose is mainly to give the airspace behind the water pump a place to expand into the atmosphere, and a place for the coolant to escape when the water pump seal goes bad. Every vehicle I can think of, if it has a water pump, its got a vent hole. So, what you are faced with is replacing the water pump with a new one (seals and individual parts are not available for the water pump on your Honda).

google

torqued to 20 ft-lbs. Torque in steps using a criss-cross pattern untill you get to 20 . good luck.....

Make sure all your fuel lines are snug on the petcock valve and carb.

20 - 21 ft/lbs

clean the carb and airfilter and put a thin film of oil all over it to catch dust etc !

clutch needs ajustment-getta a repair manual for that model-

are there 2 x bolts on the fork leg bottom ? they hold the spindle in place ! They should be easy to do pal ! P...

does it have a spark ? remove plug , place in hand and crank , do you feel it tingle ? if not check cap is ok , remove it and put ht in hand and crank , any joy ? if not then check coil etc ! P...

srip carb and replace fuel and oil mix ! replace spark plug too ! P...

check the ht wire ok , resistance on the plug cap not too much ! ignition coil wires etc ! place ht without cap or plug fitted against the head or in your hand if your brave and crank over to see if there is a spark ! ?? P...

was piston mated and messured to new liner ? can you compression test it ? 100 psi and above ONLY ! What 2 stroke mix , make did you use ? P...

remove old fuel , strip and clean carb ! new plug ! fuel goes off !! P...

anything below 100 psi is usless !! New piston and rings kit etc , check for wear and damage ! P...

remove airfilter , loosen airbox then undo both clips either side of carb , remove fuel pipe , tilt carb towards you so you can remove the cable and throttle slide and put to the side hanging ! press the rear tube between airbox and carb , soft , then pull carb out !! pictures or vidio as you start ! P...