20 Most Recent
2005 Honda CRF 250 R Questions & Answers
Rust remover
Only way to properly remove rust is using a emery paper, a wire brush and/or sand blasting. When cleaned prime and paint.
For scratches on paintwork you could try cut & polish compound found in auto stores.
Leaking honda
float level set to high or bad needle valve also could have a speck of dirt keeping it from sealing
Can not blled front brake
Attach bleeder tube to nipple place open end in bottle Open reservoir fill with proper fluid
With nipple closed squeeze brake handle then open nipple
Close nipple before releasing brake
Repeat until no air comes out and breaks feel good
Without a power bleeder this will take some time
Oil Change to Honda CRF250r 2004
the engine has two seperate sides which require oil... your owners manual should break it down step by step, if you dont have one id advise strongly to get one, but if not the right side has a 8mm bolt, remove it with the bike in a perfectly vertical position... if oil comes out its full... along with the dipstick on the left side, its pretty self explanitory on how much, just dont put too much in or you could blow seals and you will lose a slight amount of power... both sides use the same oil so you dont have to worry about clutch oil and all that ****... just use motorcycle 10w 30 or whatever... strogly advise hondas line of oil specially tuned for honda engines. keep up on it and that engine will last longer than you expect. have fun and be safe.
Not finding what you are looking for?