20 Most Recent
2005 Honda VT 750 Shadow Aero - Page 3 Questions & Answers
I have purchased a new
I would say not the starter or otherwise as soon as the battery is connected the engine would turn.
I would say if when you touch the battery lead to the battery you get a spark, check the regulator box.
Hope that fixes it.
2006 Honda Shadow aero 750 Problems starting
If the problem start after putting Vance & Hines Pipes, then try to sync the carbs, if not possible (meaning turning the sync screw all the way and cant sync them), reJet the carbs with 1up, slow and main Jet.
I recently changed the oil on my 2005 Honda Shadow
If you have a fuel pump, that could be the problem. If the pump is not working, only 1 cylinder will get some fuel. Maybe water came into electrical part of the pump and shot the fuse, just check the pump operation.
Honda 750 gas leak from carb
First of I,d just give the carb a few light taps with small hammer when engine is running it usually unsticks the needle and seat and it then clears and clean lts self. If dosn ,t work then clean pull apart carbies and blow out with compressor try easy way first half the time it works good luck neil
80 XL500S Bike runs few minutes and dies like its out of gas
I,v got one as well 2 things can cause that, petrol or spark,check to see if the float is set right height and needle and seat aren't blocked and only letting a tiny amount of fuel threw you should pull carb apart and give it agood blow out with compressed air and clean the jets I think there are 2 if remembered if its starting,normally its a fuel problem could be tank tap halved booked as well normal on bikes been sitting awhile then after that get anew spark plug sometimes they start breaking down when get hot 9 times out of ten that's your problem any way try that it should work good luck
I have a 2005 honda shadow aero. I'm not much of
Sounds like a bad ground. Check your ground wire, it should be near your battery. It will be connected to the frame with a bolt take it off a clean it and the frame with wire brush. Make sure you clean it to down to bare metal.
Not finding what you are looking for?