20 Most Recent
1996 kawasaki EN 500 Vulcan Classic Questions & Answers
New battery, but no ignition lights come on
Have you checked the main fuse? It's usually a 30amp fuse by itself and if you tried to jump the bike and connected the cables wrong, or accidentally connected the battery cables wrong when you put the new battery in, you may have blown the fuse.
I have a 1995 kawasaki
Not sure if it helps but I have had lots of problems with my switch gear. If I fiddle with it and keep trying to turn it on eventually 'I find the ignition lights up !Z!
I just got a EN 500 and need to know how all the
You have a vac tube to front of fuel tap, larger one to rear of carbs top. A balance tube going across from both sides. Its fairly simple But if you own the bike buy a Haynes manual it will save you loads
SHOW SIGNAL LAMP DIADRAM
Hi and welcome to the site,
Perhaps either could be of help:
- wiring diagram EN500A, click here;
- wiring diagram EN500C, click here.
Good luck and thank you for asking.
HOW DO I DRAIN CARBURETTORS ON KAWASAKI EN500
There is a screw underneath the carburetor float bowl chamber on the very base of the carburetor, undo and remove. Alternatively, there are four cross head screws on each corner of the bowls, remove these and cup hand under bowl to remove as there is a fibre gasket and may stick to either or both parts. Remove bowls to clean out any sediment and carby jets can be accessed inside bottom of the carburetor's.
Cheers.
How much and what grade oil goes in the forks of a
You have to get the book on this one to redo your forks, If you are replacing a seal or just topping them off, you shouldn't have a leak, but the fork oil is special from any bike shop and the amount is kinda critical, so find a book with the amount of oil needed. Usually you would remove the forks, lay them in a big long pan, pull the ends, and pull the springs and seals out, squeeze them back together and fill them with oil. Hope this helps.
Not finding what you are looking for?