2006 kawasaki KX 125 - Answered Questions & Fixed issues
Hey i want to service my kx 65 2006 and I want to
If this is a 2 stroke engine it does not require an oil change.
If this is a 4 stroke engine most motorcycle manufacturers recommend 10W40 oil and an engine that size should require approximately 3 QTS of oil. However, personally I have always used 20W50 in all of my 4 strke motorcycle engines. You also mentioned a problem what is the problem with the KX 125?
WHAT IS THE CORRECT FUEL TO 2 STROKE OIL RATIO FOR
It all depends on what type (and brand) of two stroke oil you're using. For example, some non-synthetic two stroke oils are supposed to be mixed at a ratio of 20:1. While most synthetic oils are designed to be mixed anywhere from 36:1 to 100:1. Your best bet is to follow the advice of the folks at your dealer as to the type of oil to use - and then follow the recommended mixing ratio as detailed in the oil manufacturer's instructions.
Engine cut out now it wont start.
hi mate i got an kx85 but haver never come accross this problem check the reed valves are not sticking and check to make sure the exhaust port is clear not full of carbon build up also check air filter is clean not cloged good luck
Was driving my o6 kx 85 . was at full speed and it
Check your compression,,Maybe you blew the rings,or the reed valves,,,oh,,you did check that you have fuel,,right?
Engine cleaning
I've been using the s100 cleaner. Never tried the brightener. I get mine from a sorta local (25 miles) shop
1993 ninja no power under load
could be the float , clean carb again . if it was me id check the compression , easy stuff first . then check the spark output to know if your getting weak spark after its warmed up . the service manual explains how to check the electrical system.
Removing gear lever Kawasaki KX 125
Does it have a pinch bolt? If so undo and remove the pinch bolt, if the lever doesn't slide off you will need to pry the pinch part of the lever apart. It should then slide off. If it is worn it will hang loose, you will need a new lever, also check the splines on the shaft.
Witch way do the grooves go on clutch on 87 kx125
Instructions
-
Street Motorcycles
-
1
Mount your Ninja or Eliminator motorcycle and lift it off of
the kickstand. Insert the key into the ignition and turn it to the "ON"
position.
-
2
Reach down to the base of the fuel tank with your left hand
and turn the fuel valve, or petcock, to the "ON" position. This will
place the fuel valve lever in the 6 o'clock position.
-
3
Place the engine kill switch on the right handlebar into the "RUN" position.
-
4
Pull in the clutch lever and depress the starter button on the right handlebar to start the motor.
Not finding what you are looking for?