20 Most Recent
2008 kawasaki KLX 110 Questions & Answers
I have a 2008 kawasaki klx 110. i have wanting to
Depending on your size and weight, I would suggest that you obtain a set of KX65 forks, get the mod tripple clamps, and replace the whole front end. Its pricey but worth it.. look at fastminnis.com or any pitbike website for further information on klx110 mods. Good luck
What can't get wet on my KLX 110?
Number one try not to submerge in water! Depending on the riding that you do, try not to get water in the air filter houseing, and try not to let engine sit in water long while crossing creeks. If water gets into the stator houseing which is located on the.... left side of the motor, it will short out and you are stuck with no spark. Other than that your good to go... GO RIDE!!!!!!!
Klx 110 started smoking grey smoke
If the level of engine oil keeps going down (even in very small amount), then it shows a problem with piston rings.
Hope it helps and let me know if you need more advice.
Please don't forget to rate the answer it helps me, thanks!
How to remove tire from rim on klx 110
You have to pry it over the rim with a set of tire irons. Let all the air out, pry one side off. Then remove the tube, then get the othe side. Be careful not to pinch a hole in the tube. Not easy or fun. I've seen lots of people do it in under 15 min. Not one of them was smileing. :)
Gas coming from black tube
Hi and welcome to FixYa,
Initially and to my knowledge, some of the hoses connected to a carb would be:
- from tank through fuel shutoff valve;
- overflow hose;
- drain hose;
- in some case a vacuum hose.
Of the above, the only possible hose that would fit your description would be the overflow hose. Should this be the case, then this indicates that the float inside the carb's bowl has not moved up to engage/close the inflow valve. A workaround is to tap the bottom of the bowl to jar the float to go up as well as the shutoff the inflow valve. The drain hose would also allow fuel to flow out from the carb but that would mean the drain screw is loose/opened.
Good luck and Thank you for using FixYa. Happy Holidays.
Pls be informed that due to my current rank and rating, even a
Helpful would be detrimental to my status. Should this solution not address
your concern, it would be appreciated if you could just not rate it at
all. Cheers.
Oil capacity
1.1 liters it says this on the block on the right side of the engine
Klx 110 locked up engine
From sitting or from riding?
If from sitting, pour some thin oil like ATF into spark plug hole, let sit for a day and try to push start it with plug out to loosen up...
When loose, pull off head and clean up cylinder and put in fresh rings at the least...
Kxl 110
Not sure by free wheels, does the motor turnover and seems to free wheel? If so, you may have very low compression in which the piston rings and or pistons may need to be changed, which is common if the bike is rode hard, the interval change is about 35 hours on these parts in most cases. If You kick the motor over and there is no tension on the kickstarter the spring may be bad.
Can you put two stroke
You can put the 2 stroke gas in if there's nothing else available and you're in a pinch but it will eventually foul the plug and create carbon in the combustion chamber if you do it regularly.
What oil goes in a
10w-40 is in the transmission. Two stroke motor oil is in the container under the side cover.
To start and run my
Remove and clean the carb. disassemble the carb then soak the carb parts in denatured alcohol for a couple hours then spraying with an aerosol carb cleaner should do the trick. Drain the gas tank and put in fresh gas. Go ahead and install an in-line fuel filter to lessen problems from a rusted gas tank.
Got a 1984 110klt. runs
You have a case of bent shift forks. Getting parts will be your first problem. Finding someone willing to work on it will be your second problem. The entire motor and gearbox must be torn down to get to the forks. The bike may run well and even look really nice, but it probably is not worth the time and cost of fixing it... Sorry.
Not finding what you are looking for?