20 Most Recent
2008 kawasaki Ninja 250R - Page 8 Questions & Answers
2008 ninja 250 won't start!
try testing the main fuse to see which side of the circuit is shorted. test for ohm, is it battery side or relay side. try removing the fuses from junction box and checking for a short there
Need help
if its the right key, then use picks to extract the key piece, and have new one made. or find the largest red wire exiting the switch, apply power, may also be more than just this wire that needs power on some bikes.
250 ninja dropped on right side at 0mph. signal
Go to Powersportseast.com and look up your bike on the Parts Fische. It will give prices and you can order thru them if you want. Signals are the cheap part by a long shot! I have been rebuilding a Salvage 08 250 ninja and have had to replace A LOT on it. The plastics alone are around 250-350. If it is really bad on the plastic try Ebay and wait till you find exactly what you need. The signal is around 40 bucks give or take
My bike never wants to shift in to neutral once
you should try by changing the oil , use a slightly thicker oil and you will see it will improve it .
its common this days as oils are very thin and high lubrication at hot stages looses its capacities .
try that first
Droped bike handelbars r straight and front wheel
You need to loosen and re-torque the fork triple clamp bolts, along with the front wheel axle, and pinch bolts. Do this with the front wheel off of the ground. Your forks may have twisted, and all needs to be loosened, straightened, and re-torqued.
Note...you can destroy forks if you don't properly torque tripple clamp bolts!!!!
Best shop/people for ninja250?
It will depend on budget. we can get a total of 200hp with a turbo but you will need a 30k budget. I would start by poking around on zx-10r.net in there 250 forum
Cant figure out how to reattach throttle cables
adjust the cables to were they are as loose as possible. one cable should be for snap back and the other for the actual throttle. you will have to put the housing on the bars and the throttle sleeve on the bars, then install the cables in the throttle sleeve.
Where can i download a wiring diagram for a 2009
You have a newer bike which should make it easier to get the Haynes Owners Manual.
Have you tried a bittorrent like btjunkie.com, mininova.com etc.
And use Utorrent (rated one of the best) similar to Kazaa, and napster and try searching there.
Thats where I found my manual.
-jay
Ignition
These bikes have a module that will not alow the starter to engage if the battery voltage is to low. You need to hook up a battery charger and ck the battery voltage. If battery voltage is below 12.oo vdc it may not start. Ck your voltage, ck your fuel, be sure you have fresh fuel before you start it or you will run down the battery again.
I have a 2009 ninja 250r that i slid and i was
hi mate you can installl them your self the are held in by 2 bolts or a nut on the inside just unscrew that and disconnect the 2 wires also you can buy them cheap fom somewhere like ebay
My 2008 Ninja 250 tires to start itself
The switch is the most likely source of the problem. Check it with a volt ohmmeter. Put the key in off and check the terminals. Next turn the key to the 1st position and check the terminals then on any further positions. The next time the bike self starts is when you want to re-check the switch terminals.
You know, this has all the signs of an internal short in the switch. Just tell the dealer to give you a new switch. Switch failure after 5 hours of riding is simply unacceptable.
Not finding what you are looking for?