20 Most Recent
1994 Suzuki GSX 600 F (Katana) Questions & Answers
Gsx 600 wont start
Does the clutch lever need to be pulled in if it's in gear and you try to start it? Try making SURE it's in neutral before you try to start it.
Also check to see if it has a kickstand lockout switch that might be preventing it from cranking.
Wont stay started
well it sound like vacuum leak to me take some carb cleaner or brake cleaner and spray around throttle body see if bike rev up or cuts off hope this helps
How do you remove the seat? i have tried but it
Hello Jerome - to remove your bike seat, locate the two bolts on either side of the seat, towards the front by the gas tank. Remove the two bolts under the seat using a ratchet & socket...Grab the seat from the front by the gas tank and lift it up until the seat is around a 45-degree angle to the frame. Then pull the seat towards the gas tank to release the rear tab that locks the seat in place at the rear by the fender... I hope this information is helpful.
Position on a petcock for a 1994 suzuki katana 600
I have the same problem on my gsx 600f! there is no markings to say which is ON, or PRIME, or RESERVE on the petrol tap!
I'd like to know before I run out of petrol on reserve!
Is the ON position with the arrow pointing down? lots of people seem to be asking the same thing across the web! Can we have a solution please!!!!
When holding clutch and putting into first gear, completely dies
whats happening is your clutch plates are sticking together. try tightening up the clutch cable a bit. im not sure if it is cable, it may be hydraulic? if it is, then bleed the clutch to get any air out of the system. if that doesnt work, then try an oil change. sometimes old, thick oil wont let the clutch plates seperate, and you get that jerking when your engine is cold. use a light oil. maybe 5-30 or 10-30. a light oil will make it easier for the clutch to disengage.
I recently bought a 1994
sounds like 2nd gear failure,which is motor out and split to repair,go to your dealer and get them to test ride,
Hello there.
a thermal senser controls the ignition and could be shutting down at a preset temp
Ihave a drop foot from a driveby shooting.and i
what does a "drop foot" entail? if you cant shift its bad linkage or bad tranny. are any parts of the shift linkage touching each other or the case? can you push the bike with the clutch in and in gear, if you cant your tranny is toast.
Not finding what you are looking for?