Top 20
1994 Suzuki GSX-R 600 Questions & Answers
Suzuki gn 125 lacking power
I assume you dumped out the half pint of old gas and rinsed out the tank. Get a new spark plug and clean the air filter. Remove the carb and dis-assemble it then soak the parts in denatured alcohol for 30 minutes. Do not soak the rubber diaphragm. Finish the cleaning with a can of spray carb cleaner from the auto parts store. Be sure all internal fuel and air circuits are clear and that the diaphragm is not torn or has pin holes. The top cap must have a good seal. Go to www.babbittsonline.com/parts/viewbybrand/parts.aspx to see a diagram of the carb and the rest of the bike. It looks like they have lots of parts for your bike.
Gsxr 400 1994
how we feel spark has most to do with skin type than voltage. color of spark is a little helpfull shound be blue to white. has the bike been in storage? set the plug gap and try a little starting fluid.
Shift rod is pushing on the case cover
PULL IT ALL DOWN AND TRY PUSHING IT AGAIN, SEE WHERE THE PRESSURE IS, Noit sure what the soloution is mate, but might need a strip down on the clutch cover side as well, oil drained and have a look whats going on.
Why would my turn signals stay on my 08 Street glide
You may have some bulbs with burned out filaments, Or the bulbs may not be in correctly. Pry off the lens cover with a dime and inspect the bulbs. Make sure they have two filaments. If one filament is broken, replace it with a new bulb. Bulb #1157
Doesn't start when its hot
That could be fuel related or electrical related.
Without more details its hard to give advice.
If you have an aftermarket fuel controller dis-connect it and use the factory controller. If that fixes it your controller has a problem. If you have a factory controller it may also have failed. Could also be a fuel pressure issue, bad pump.
Best the have the dealer pull the codes to find out exactly what has failed.
Rear brakes sticking
push back the pads if possible and then press the brake and see if they return ! if not then remove the pads and clean where they fit and press the brake a little so the pistons come out then gently clean off then push back in and refit pads and try !
Cutting out
Almost sounds like a vacuum lock ("it feels like it running out of fuel"), like the gas tank isn't venting.
Air has to be allowed into the gas tank to replace the fuel leaving it.
Next time it dies, open/take off gas cap and see if it fires up right away, instead of having to wait 10 minutes.
If that works, start looking at the vent lines and see if it's plugged, or a one-way valve isn't working, or the line is pinched.
I wanna put my 97 ex 500 clutch in my 97 gsx r 600
find the OEM part number for your clutch plates (theyre differsnt ones for 3 or 4 of the plates you can buy seperate or a pack for your year and model). Go to a parts fiche site to see what other makes and models are compatable with your part numbers. I use ronayers.com
Cutting out idle
is idle set too low , should be an adjuster knob to increase it ! if not remove fuel tank and adjust throttle stop screw in centre of carbs where cables connect to carbs
I have a 2000 gsxr 600 that runs fine but for some
Hello,Your bike has a safety interlock built in that will need to be thought of when you try to start the bike. The Kick stand needs to be in the UP position, not toward or resting on the ground if the transmission is in any gear other than Neutral. In other words the neutral gear the bike will always start regardless of the kickstand's position. On the other hand if you are in gear and put down the kickstand without thinking the bike will shut off.
Not finding what you are looking for?
