Top 20
2003 Suzuki VZ 800 Marauder - Page 6 Questions & Answers
Where is the rectifier located on a 2001 suzuki intruder 800
The rectifier on a 2001 Suzuki Intruder 800 is typically located near the battery, under the seat. It is usually attached to a bracket or secured with screws to the motorcycle's frame.
To locate the rectifier, you may need to remove the seat and possibly the side panels. Once you have access to the battery, follow the wires that are connected to it. The rectifier should be mounted nearby and have wires connected to it as well.
If you're having trouble locating the rectifier or need further assistance, I would recommend referring to the motorcycle's owner's manual or consulting with a qualified motorcycle mechanic.
2/20/2023 3:23:59 AM •
Suzuki...
•
51 views • 0 helpful votes
My 2007 King Quad 450 Suzuki will not start with the green start button but I can use the pull rope and it will start and run fine. what is the cause?
It sounds like there may be an issue with the starter circuit on your 2007 Suzuki King Quad 450. The fact that the bike will start and run fine when using the pull rope, but not when using the green start button, suggests that there is a problem with the connection between the button and the starter motor.
Possible causes for this issue include a faulty starter button, a broken or corroded starter relay, or a problem with the starter motor itself. Additionally, there may be an issue with the wiring or connections in the starter circuit that is preventing power from reaching the starter motor when the button is pressed.
It's recommended to check the wiring connections and fuses, and ensure they are all secure and not corroded. And also check the starter relay, it might be malfunctioning and preventing power from reaching the starter motor when the button is pressed. If the problem persists, it's best to take it to a professional mechanic to diagnose and fix the issue.
1/23/2023 4:32:54 AM •
Suzuki...
•
100 views • 1 helpful votes
Wiring diagram for a 2000 model Suzuki quadrunner
limited info generic answer this is service manual for 250 if not the one do onlinr search and include all info on atv --------------http://www.crservice.dk/Suzuki%20ATV/LTF250/LT-F250_01E.pdf
2/9/2023 8:15:42 PM •
Suzuki...
•
61 views • 0 helpful votes
Katana Suzuki fuel line diagram?1990 rf 600
Here is a general fuel line diagram for a 1990 Suzuki RF 600 Katana:
- Fuel tank: The fuel tank holds the gasoline and is typically located on top of the motorcycle frame.
- Fuel petcock: The fuel petcock is a valve located on the bottom of the fuel tank that controls the flow of gasoline to the engine.
- Fuel filter: The fuel filter is located between the fuel tank and the carburetors and helps to remove impurities from the gasoline.
- Fuel lines: The fuel lines connect the fuel tank, petcock, fuel filter, and carburetors together in a specific sequence.
- Carburetors: The carburetors mix the gasoline with air and deliver the mixture to the engine cylinders for combustion.
The exact fuel line routing and connections may vary depending on the specific model and year of the Suzuki RF 600 Katana, so it is important to refer to the owner's manual or a detailed service manual for accurate information. Additionally, any modifications or repairs to the fuel system should be done by a qualified technician to avoid damage to the motorcycle or injury to the rider.
1/12/2023 11:44:21 AM •
Suzuki...
•
115 views • 0 helpful votes
Suzuki Burgman 125cc 21 plate
If you are having difficulty moving your Suzuki Burgman 125cc scooter backwards, there could be several reasons for this, including mechanical issues or problems with the scooter's weight distribution. Here are a few things you can try to diagnose and fix the problem:
- Check the weight distribution: If the weight is not distributed evenly on the scooter, it can make it difficult to move it backwards. Try adjusting the position of the scooter or shifting your own weight to see if this helps.
- Check the brakes: If the brakes are engaged or not properly adjusted, it can make it difficult to move the scooter backwards. Check the brake lever and make sure it is released, and try adjusting the brake cables to see if this helps.
- Check the wheels: If the wheels are not properly aligned or there is damage to the tires, it can also make it difficult to move the scooter backwards. Check the wheels for damage or wear, and have them aligned if necessary.
- Check the engine and transmission: If there is an issue with the engine or transmission, it can affect the scooter's ability to move backwards. Have a mechanic inspect the engine and transmission to make sure everything is working properly.
If none of these solutions solve the problem, it's possible that there may be a more complex issue with the scooter. In that case, it's best to take it to a certified mechanic for a professional diagnosis and repair.
2/10/2023 11:01:36 PM •
Suzuki...
•
54 views • 0 helpful votes
Wire a aftermarket fuse block on a 1984 suzuki GS550L
Installing an aftermarket fuse block on a 1984 Suzuki GS550L can help protect your electrical components from damage due to power surges and short circuits. Here are the steps to wire an aftermarket fuse block on your bike:
Materials:
- Aftermarket fuse block
- 10 gauge wire
- Wire cutters/strippers
- Crimping tool
- Ring terminals
- Zip ties
- Electrical tape
Instructions:
- Locate a suitable location for the fuse block on your bike, such as under the seat or on the frame.
- Disconnect the battery to avoid any accidental electrical discharge.
- Determine the total electrical load that will be connected to the fuse block and choose a fuse that is appropriate for the total amperage required.
- Use the wire cutters to cut the 10 gauge wire to the desired length for each circuit, leaving extra slack for any bends or turns.
- Strip the ends of each wire using wire strippers, exposing about 1/4 inch of bare wire on each end.
- Attach one end of each wire to a ring terminal using a crimping tool.
- Connect the ring terminals to the appropriate circuits on the fuse block, following the manufacturer's instructions.
- Secure the wires and fuse block to the bike frame using zip ties, ensuring that they are not interfering with any moving parts or causing any obstruction.
- Reconnect the battery and test the circuits to ensure proper functioning.
- Finally, wrap the exposed wire connections with electrical tape for added protection.
Remember to double-check all connections and ensure that the fuse block is properly installed and grounded to avoid any electrical issues. It is also recommended to consult a professional if you are unsure about any of the steps.
2/15/2023 2:30:17 AM •
Suzuki...
•
37 views • 0 helpful votes
Where can I download a Suzuki s83 1400 repair manual
https://www.carlsalter.com/suzuki-service-manuals.asp -------------------https://www.repairmanual.com/product/official-1987-2008-suzuki-vs1400-intruder-volusia-boulevard-s83-factory-service-manual-99500-39159-03e/
11/20/2022 2:26:46 AM •
Suzuki...
•
92 views • 0 helpful votes
1992 Intruder 800 VS.. I have coolant leaking out of frame..I want to insert a hose through the frame for the coolant flow..what size and type of Hose should I use?
The best size and type hose to use is the same as what was used in the radiator. Your local auto parts store will have it. If you need more help with this, let me know. Good luck. ... 1992 Suzuki VS 800 Intruder The best size and type hose to use is the same as what was used in the radiator. Your local auto parts store will have it. If you need more help with this, let me know. Good luck. ...I am having a problem with coolant leaking out of the overflow. I have checked the radiator, water pump and hoses. No leaks there. I have 2 theories. First theory is the head gasket. I have not checked that. The other is the thermostat. When the coolant is cold the overflow is almost empty. When it gets hot the overflow is full. I have replaced the coolant and the overflow is full again. Any ideas?More than likely the thermostat is not opening up, when the coolant gets hot and the engine is running, the thermostat should open and the coolant should flow from the radiator to the motor and back, causing the overflow to empty out, now when it gets ... 1995
11/4/2022 8:03:43 PM •
Suzuki...
•
108 views • 0 helpful votes
Not finding what you are looking for?