How to replace starter on boulevard c50
It is a lot of work and there are no short cuts, as I tried what some other people offered????
You will need to remove, passenger seat, rider seat, positive battery cable, side covers, toolbox case cover,
Remove coolant cover case, drain coolant from reservoir, and remove to clean and inspect
Remove clutch cover, loosen all clutch play, then remove cable from lever to allow slack and it to be moved out of the way in the engine area.
Loosen hose to water pump and drain,
rear exhaust pipe and muffler ( saddle bag if applicable), you may have to loosen rear holding bolts for #1 muffler to allow play to disconnect the joint between the 2 mufflers,
Disconnect coolant tube housing (3 - 8mm bolts) in the back of the 2nd cylinder, there is also a 2 bolt angle joint to the coolant
Remove starter motor cover (7 mm wrench), remove the 2 bolts holding in the starter motorin and the lead to the starter motor. Starter motor needs to be played with, jiggle and pryed gently to remove( out the exhaust side) and similarly to install and reverse all other procedures.
To refill radiator undo tank bolt and pull back to reveal radiator cap at the top left side remove cap and add new fluid., other fluid can be added to the reservoir