20 Most Recent 2005 Yamaha XT 125 X - Page 6 Questions & Answers

The Fz400r is a motorcycle engine produced by Yamaha. To set the timing mark on the Fz400r, follow these steps:

1. Remove the side cover from the engine to expose the timing mark.
2. Locate the timing mark on the rotor, which is a small line or notch on the outer edge of the rotor.
3. Use a timing light to align the timing mark on the rotor with the "T" mark on the stator.
4. Loosen the bolts that secure the stator plate in place.
5. Adjust the position of the stator plate until the timing mark on the rotor is aligned with the "T" mark on the stator.
6. Tighten the bolts that secure the stator plate in place.
7. Reattach the side cover to the engine.

It's important to consult the Fz400r's service manual for detailed instructions on setting the timing mark and to ensure proper timing of the engine.

This could be an error in the coolant temperature sensor's reading or it might be a sign of a more serious issue with the cooling system, like a coolant leak or a clogged radiator. You might need to bring the scooter to a repair shop to be examined.

Yes it is a speed sensor issue, but that is normally nothing to do with the speedometer if it has a cable. The speed sensor is part of the electronic engine management system which is why the Scooter lost power. Here is your Service Manual. Use CTRL+F and type 'speed sensor', and press Enter. 15 mentions of it. https://www.49ccscoot.com/manuals/Yamaha_C3_Service_Manual.pdf Location (not a detailed as I would have hoped) https://www.google.com/search?q=2007+yamaha+c3+speed+sensor+location This suggests the battery may not be fully charged https://www.justanswer.com/motorcycle/5om11-2007-yamaha-c3-scooter-getting-error-code.html ..

In this link, but it is better to specify the part you want the torque for. https://www.google.com/search?q=torques+specs+for+a+2004%2F5+Yamaha+G22+golf+cart ..

A motorcycle that turns over but doesn't start can be caused by a few different things. Some possible causes of the issue you are experiencing with your 2008 Yamaha V Star include:

1. Fuel supply problem: If the fuel pump is not working properly or the fuel filter is clogged, it can prevent fuel from reaching the engine.
2. Ignition system problem: If there is no spark at the coil packs, it could be due to a malfunctioning ignition module, a bad spark plug, or a problem with the ignition coil.
3. Mechanical issue: If the engine is not getting compression, it could be due to a valve problem, a broken timing chain, or a seized piston.
4. Electrical issue: If the engine is not getting power, it could be due to a dead battery, a corroded connection, or a problem with the starter.

It's best to check the battery and all the electrical connections first, also check if the spark plugs are fouled or damaged, if so change them

i assume its automatic transmission-so check the trans fluid level & top up if necessary

It is likely that there is an issue with the cruise control system on your Yamaha Royal Star Venture. Without more information about the specific symptoms and troubleshooting steps that you have already taken, it is difficult to provide a specific diagnosis. Some possible causes of cruise control not working on a motorcycle could include a malfunctioning cruise control module, a problem with the throttle position sensor, or a failure in the wiring or connections related to the cruise control system.

You need a wiring diagram or service manual to check the way the circuit runs and whether it earths via the points or earths via the coil. The way the spark works is that the coil is energized all the time the ignition is on and the spark is created when the the points *break* the contacts. You will only have power at the points with the ignition on and only on one side with the points open. Various resources in the link, but none that I am willing to register for. https://www.google.com/search?q=1971+yamaha+dt250+ignition+wiring+diagram ..

Question edited for clarity. Badly adjusted clutch. Incorrectly fitted clutch. Sticky plates, did you oil them? https://www.google.com/search?q=2012+Yamaha+V+Star+950.+I+installed+new+clutch+on+it+and+now+the+clutch+will+not+disengage ..

This has some information, but not as much as I would like https://www.google.com/search?q=2009+Yamaha+Raider+speedometer+wiring+diagram However, the Service Manual is here. Page 412 is what you want. https://www.mediafire.com/?ekm1dodyyin ..

frankly if it were mine and if runs great now then let it run .. the leaner the mixture the hotter the combustion which can burn valves. it might get better mileage after break-in but if 40 is what you got then 40 might be all you get.. Thats about what my vulcan gets. if you want really high MPG then you have to sacrifice speed .. a moped will get around 70MPG but it's not much fun and has no power to get out of the path of danger

Nope, with your attitude, you will be finding it yourself. Buy a manual. In my day no one used torque wrenches anyway!

https://quads.ddns.net/service-manuals/yamaha/Warrior.pdf ---------------------- https://www.manualslib.com/manual/941548/Yamaha-Yfm350x-Warrior.html

Wiring under the seat, broken wires or a connector came apart. Possibly bulbs but unlikely. Check with a meter or a wire and the battery.

this forum has the service manual --the troubleshooting guide can assist you ---------------------------https://www.blasterforum.com/threads/yamaha-blaster-parts-service-and-owner-manuals-free-download.17325/-

Question edited for clarity Question moved from Garden category! https://www.google.com/search?q=2005+Yamaha+TT-R+90+E.+Fuel+line+diagram Service Manual https://www.google.com/search?q=2005+yamaha+tt-r+90+e.+service+manual ..

Hi, please double check that all the parts your replaced are compatible with your vehicle. Compatibility would be the only thing that I can think of. You might want to have a mobile mechanic diagnose the issue as well so they can see everything firsthand. They might use a multimeter to test all points of electric signals possible to make sure that each points is passing some type of current and there are no dead wires. Thank you.

Engine oil w/o filter: 3,2 L SAE 10W40 Engine oil with filter: 3,4 L MIN. API SE

All vehicles built after 1927, for road use, must have a working tail light. Yes it has one, probably needs a new bulb or reconnect the socket on the mud guard.