Reset Maintenance warning light on Lexmotto Michigan 125 efi
After nobody could help me reset the maintenance light on my lexmotto michigan 125 efi. Here is how I solved it.
remove the seat and underneath u will see the relay
Just unplug the relay and keep unplugged for a minute. Plug it back in put seat back and the light is gone. a minutes work and lexmotto would not tell me this.
Sorry for my bad english!
I try to explane how to reset the EFI lamp:
1. bike in key-on and engine off
2. Near the ECU under the seat there is a 6 way connector (the diagnostic connector), but only 5 way are filled by cables;
3. With an electric cable or other you must connect togheter the 2 pin on the side where there is the hole for exactly 12 sec!
4. After that, the EFI lamp make a series of pulse to indicate the errors occours and then reset the errors memory!
Bie
I copied this from the the aprilia forum (just google it). A good first port of call. In fact, any forum relating to any bike you own is always a great place to start searching
I don't know this machine but if it is any help on my Yamaha TW125 the seat is held by 2 6mm bolts underneath. The top rail of the sub-frame has 2 small plates that the bolts go thru. Try looking under the seat from the chain side use a torch and you should find the answer I hope. Good luck.
The battery is underneath the rear seat.Lift the driver's seat, remove the two bolts holding the rear passenger seat and you will see the battery.This will help I thinkwww.malagutiscooterspares.co.uk/spares/epcimages/7585/14.jpg
×