SPEC Motorcycles - Recent Questions, Troubleshooting & Support
Torque spec for front drive sprocket 2017r1
The torque specification for the front drive sprocket on a 2017 Yamaha YZF-R1 (R1) motorcycle is typically around 90 Nm (66.4 lb-ft). However, it's crucial to consult the service manual for your specific model and follow manufacturer-recommended torque values to ensure proper installation.
Need help finding the Alternative Speed Display
To change the digital odometer display setting from mph to kph on your 2017 Volkswagen Tiguan, you will need to activate the alternative speed display option. If this option is not currently available on your vehicle, there are a few possible reasons why this might be the case:
- Different region settings: Depending on the country or region where your vehicle was sold, the alternative speed display option may be enabled or disabled by default. If your vehicle was sold in the US, it is possible that this feature was disabled in the region settings.
- Software update: It is also possible that a software update has removed or disabled the alternative speed display option on your vehicle.
- Model differences: While previous Volkswagen Tiguan models may have had the alternative speed display option, it is possible that the 2017 model may not have this feature due to differences in the vehicle's design or features.
To activate the alternative speed display option on your 2017 Volkswagen Tiguan, you may need to contact a Volkswagen dealership or service center in Germany. They will be able to provide you with more information about the specific region settings and software updates for your vehicle, and may be able to activate the alternative speed display option for you. You can also refer to the vehicle's owner manual or contact Volkswagen customer service for assistance.
Where is the oil filter on a 2000 ford expedition?
I myself have the same vehicle ;and today just bought a new fuel filter to replace the old one ; it is located on the drivers side of the vehicle on the under carriage. You should be able to change it with a pair of pliers and a drip pan.
John
Need circuit diagram for ARLEC 15e 6-24Volt 15Amp Electronic battery charger OR their later model BC58
I can't find a diagram.
The small potentiometer on the control board likely serves as an adjustable component to fine-tune specific parameters. Here are some possibilities:
Voltage Regulation:
The potentiometer might control the output voltage. By adjusting it, you can set the desired charging voltage for different battery types (e.g., 6V or 12V).
Current Limit Adjustment:
It could be used to set the maximum charging current. Adjusting the potentiometer allows you to limit the charging current based on the battery's capacity and condition.
Sensitivity or Threshold:
Some potentiometers act as sensitivity controls. For example, it might adjust the threshold at which the charger switches between charging and maintenance modes.
Setting the Potentiometer:
Without the specific circuit diagram or detailed information about your charger, I recommend the following general steps:
Observe the Potentiometer:
Identify the potentiometer on the control board. Note its position and any markings (if present).
Consult the User Manual:
Check the user manual or operating instructions. It might provide guidance on adjusting the potentiometer.
Trial and Error:
If no specific instructions are available, start with the potentiometer set to its mid-position.
Gradually adjust it while monitoring the charger's behavior (e.g., charging current, voltage).
Observe how the charger responds to changes in the potentiometer setting.
Fine-tune it based on your specific battery type and desired charging characteristics.
Remember that precise adjustments depend on the charger's design and the battery you're charging.
4/18/2024 7:22:52 PM •
Motorcycles
•
Answered
19 hours ago
What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks
The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/12/2024 1:26:15 AM •
Motorcycles
•
Answered
on Apr 12, 2024
Not finding what you are looking for?