Find the cable adjuster in the middle of the cable, loosen the lock nut, and turn the adjuster barrel inwards to get as much slack in the cable as possible. Take the E-clip off the bottom of the clutch lever pivot pin and remove the pin. Pull the lever out and disconnect the cable from the lever. Stand the bike straight up and drain the primary case. Down on the primary, take the round plate off to expose the clutch release mechanism. Disconnect the clutch cable from the link that connects to the release mechanism. Screw the end of the cable out of the primary case. Install in reverse order and readjust the cable. Add oil back to the primary case.
Good Luck
Steve
388 views
Usually answered in minutes!
×