Hi Eric:
Also called Ignition Coil, is located at the back of the intake manifold...
Fig.: remove the 2 lower ignition coil mounting bracket bolts...
Fig.: then remove the ignition coil and mounting bracket together from the engine.
Disengage the wiring harness connector from the ignition coil.
Disconnect the ignition wire from the coil.
Remove the coil mounting bracket bolts, then remove the coil and mounting bracket assembly from the vehicle.
The ignition coil can be separated from the mounting bracket.
To install:
If separated, loosely mount the ignition coil to the mounting bracket.
Loosely install the coil and mounting bracket assembly to the intake
manifold. Tighten the coil mounting bracket-to-intake manifold bolts to
115 inch lbs. (13 Nm) and the ignition coil-to-mounting bracket
fasteners to 96 inch lbs. (10 Nm).
Connect the ignition wire to the coil.
Engage the wiring harness connector to the ignition coil.
If removed, install the windshield wiper/motor module assembly.
Connect the negative battery cable.
Hope this helps; also keep in mind that your feedback
is important and
I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
228 views
Usually answered in minutes!
×