SOURCE: 2005 carbie starts but misses and backfires at
Did the kit come with a new needle? It sounds like it's a little lean in the mid-range. I'd pull the slide out and take the needle out of the slide. From the long end of the needle, slide a 3mm flat washer up onto the needle. Use a small dab of grease to hold it on the needle while you put it back in the slide. The small washer should be about 0.020"-0.025" thick. This will RAISE the needle just slightly enriching the mixture just a bit in the mid-range. It will not change your idle setting nor the wide open throttle jetting.
Good Luck
Steve
157 views
Usually answered in minutes!
×