2002 Yamaha TT-R 125 Logo
Posted on Mar 24, 2012
Answered

Wont idle how to adjust carb

Answer This Question

1 Answer

Doug

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.

  • Contributor 20 Answers
  • Posted on Mar 25, 2012
Doug
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.

Joined: Mar 23, 2012
Answers
20
Questions
0
Helped
17131
Points
33

Make sure your spark plug is not fouled and the gap is correct, also air filter is properly cleaned. If it still wont idle, locate the idle adjustment on the carb. There are 2 screw type adjustments there, one is the idle/air screw and the other is idle adjustment which is the one you want. Start the bike and warm.it up, slowly turn the idle adj. Inward like tightening a bolt, periodically give the engine a slight rev and let it idle.down. Do this until you reach the desired rpm you want to idle at and your finished

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

95 Suzuki kingquad 350 will not idle at all. Starts and runs OK just wont idle. How do I fix this problem?
Try adjusting the idle screw on the side of the carb. If this don't work you need to clean the carb the pilot key is blocked. Regards Jom...
Read full answer
Apr 28, 2015 • ATVs
0helpful
1answer

My new homelight leaf blower either revs too much or stops it wont idle it is the cheap model and I cant see any screws for adjustment.
idle should be adjustable , but if it was purchased in the u s of a since 2012 then sorry it's got a C.A.R.B. type carb on it ( google that acronym) and sorry fuel mixtures are not adjustable anymore the clean air folks took care of that for us! I thank them everyday for looking out for us all .

look on top of carb right next to cam that moves when you press throttle down , there you'll see a very small screw that's your idle adjustment
Read full answer
Apr 15, 2015 • Garden
0helpful
1answer

2002 suzuki twin peaks 700 wont idle. how do i adjust idle?
There should be a idle set screw on the carbs near the throttle linkage.

also need to make sure your mixture screws are set properly.

and make sure the carbs didnt sit for a long time
Read full answer
Nov 30, 2010 • 1971 Suzuki T 350
0helpful
1answer

How do you set the idle on the 353 saw. it will start and run but wont idle, then it shuts off. fire it back up and same happens
There should be a idle screw adjustment on carb.if not try adjusting the low speed jet.
Read full answer
Nov 27, 2010 • Husqvarna Garden
1helpful
1answer

Float adjustment wont idle
the floats dont often go out of adjustment, as the float needle has a rubber tip that doesent wear,
If the carb doesnt drip fuel, the level is probably ok
first try air cleaner, spark plug, dirt in idle jet or carb, tight valve clearances.
Read full answer
Apr 11, 2010 • 2004 Honda CRF 150 F
0helpful
2answers

I have a 89 klr 250 and it wont idle anymore ive
TRY BLOWING OUT THE MAIN JET ,IF CARBY IS STILL OFF.MAKE SURE YOUR AIR CLEANER IS CLEAN.
Read full answer
Feb 17, 2010 • kawasaki KLR 250 Motorcycles
1helpful
3answers

I overhauled my carb (85 22r) wont idle but will if support wiyh carb cleaner sprayed into carb. any help would be appreaceated
might have a air leak around it or the barrels aren't firing right
Read full answer
Nov 25, 2009 • 1986 Toyota Pickup 4WD
0helpful
1answer

2007 ttr 125 wont start unless hand is over the back of carb. also wont idle.At mid and high range it runs fine. There are no air leaks and no adjustment screw for the air/idle just a factory plug.
Time for carb cleaning, blow the jets with compressed air and check the fuel level in the float chamber, adjust if necessary.
Tht factory plug is where the air-mixture screw is and tht plug has been kept there for non tampering!
That screw is factory set.
Basically its the primary jet which is a problem in your bike's carb, but all in all might as well blow both of them.
Hope this helps!
Read full answer
Nov 13, 2009 • 2002 Yamaha TT-R 125 L
0helpful
1answer

Honda cr 125 1997 wont idle
Your carberautor is either gummed up or needs to be adjusted. Begin by going to an auto zone or similar store and gatting a can of carb. cleaner that gets added to your gas. Be sure to follow the instructions on how much you add per gallon. let that run through your bike for a while and see where you are. If cleaning the carb. doesn't hellp, then the carb. will have to be adjusted.
Read full answer
May 27, 2009 • 2002 Honda CR 125 R
0helpful
1answer

Engine runs but wont idle!
set you carb adjustments at 1 1/4 and try that
Read full answer
Jan 30, 2009 • Husqvarna "Chain Saw - 16" Bar, 3 Hp
Not finding what you are looking for?

View Most Popular

2002 TT-R 125

  • Motorcycles

Related Question

95 Suzuki kingquad 350 will not idle at all. Starts and runs OK just wont idle. How do I fix this problem?

  • ATVs

Related Topics

2,683 views

Ask a Question

Usually answered in minutes!

Popular Questions

2000 yamaha ttr90 fuel leaking out overflow tube

2002 Yamaha TT-R 125

Ttr 125 starts good but

2002 Yamaha TT-R 125

How do i set yamaha ttr 230 timing

2002 Yamaha TT-R 125

What is the gear pattern for a ttr125

Yamaha TT-R 125 Motorcycles

What type of oil does my 2002 yamaha ttr 125 take

2002 Yamaha TT-R 125

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...