Carbs should be just above both valve covers and slightly inward on the engine. Most anything Goldwing @ www.goldwingfacts.com
SOURCE: need accurate 1989 Honda Goldwing carbureto/hose information
Testimonial: "Thanks so much for your very timely and useful response to my inquiry. Ask and you,...(I),...shall receive. THANX !!!"
SOURCE: does anyone know where the fusebox on a honda
use the key to open gas tank cover,lift the foux tank cover,it will be on top of the air filter housing, there is also some fuses in the left fairing pocket under the clovebox.and there is a 30 amp fuse on the side of the start relay.(left side near battery)
SOURCE: where is the tps located at on a 1985 goldwing
It is on the left side at the top behind the rad , it has 3 small screws around it , they have heads that brake off when they are turned in to tork if you know what I mean . To get them out you need very small needle nose vice grips . The TPS is inside that cover.
If you need a new one , you can get one off a honda Civic Fuel injected car they are the same ,just the plug is not the same ,I did that with mine and it works just fine now !
SOURCE: how to replace a headlamp on a 1985 honda goldwing
Hello,
I see that your question is six months old and you probably have had it answered already. I will post the proper procedure for you just in case no one has helped you.
To remove the Headlight assembly, you will need to do the following;
1)
Rotate the rear view mirrors 90 degrees so that the mirrors are facing
up and remove the bolts holding the mirrors on - you will need to
remove both mirrors.
2) Remove the windshield trim panel by placing a
shop cloth over the slot between the windshield and the headlight unit.
Insert a wide flat blade screwdriver into the slot and very CAREFULLY
lift up on the screwdriver. This will unhook the latch from the holder
on the fairing. You now should be able to remove the trim panel.
3)
Remove the louver trim panel below the headlight lens. This will give
you access to the bolts holding the lower part of the headlight assembly
(remove them and pull the headlight assembly forward and slightly out
of the front fairing).
NOTE: there are screws holding the
headlight adjustment cable mechanism to the headlight case - these will
have to be removed to take the entire assembly out. Next disconnect the headlight
connector from the headlight lens unit and you're done with the removal process.
Install in reverse order.
Hope this helps.
Oz
If you find this information useful, please vote on it. Thank You.
183 views
Usually answered in minutes!
×