Key replacement can the manual book provide information about scooter key? if not how can i repace my key if i have not any left? Regards

If the lights on your Golden 3-wheel scooter won't turn off and you hear a beeping sound after turning it on, it could indicate a potential issue. Here are some troubleshooting steps you can try:

1. Check the key switch: Ensure that the key is inserted fully into the key switch and turned to the correct position. Sometimes, if the key is not fully engaged or turned properly, it can cause electrical issues. Try removing the key, reinserting it, and turning it to the correct position.
2. Examine the battery connections: Inspect the battery connections to ensure they are secure and free from corrosion. Loose or corroded connections can affect the scooter's electrical system. If you notice any loose or corroded connections, carefully tighten or clean them as needed.
3. Verify the charger connection: If the scooter is connected to a charger, make sure it is properly plugged in and connected to the scooter. A loose or faulty charger connection can cause electrical malfunctions. Try unplugging and reconnecting the charger to ensure a secure connection.
4. Check the scooter's manual: Refer to the owner's manual or user guide for your specific model of Golden 3-wheel scooter. It may provide troubleshooting steps or information about the beeping sound and lights issue you are experiencing. Look for any error codes or indications that can help diagnose the issue

Thanks for providing the best information.
Thanks & Regards
https://techprodata.com/

hi Laurie, the five bleeps is related to the brake , you need to check the connections between the axle and the frame and the connection to the brake...

Regarding a circuit diagram... Pride would never supply such a thing, it's propriety information.

Regards
Rob

hi, the manual contains the required information http://www.drivemedical.co.uk/technical/z40998a.pdf

MK size battery upto 50amps will fit that scooter...

Regards
Rob

www.gewizrepairs.co.uk

hi, the following link will contain all of the information you require

http://www.thescooterstore.com/pdf/scooters/manual/ProwlerOwnersManual.pdf


Regards


Please rate my assistance.

Sadly i cannot find a manual however I can help you with the repair because I know these scooters very well. regards GeWiz

Most Chinese scooters don't have a good service manual specifically for them, but manuals for similar models or for that engine platform (should be GY6 150 in this case) will work fine for most tasks. You can find some manuals at http://www.49ccscoot.com/manuals/manuals.html

OWNERS MANUAL DONT TELL YOU HOW TO FIX WATER PUMP OR FUEL PUMP YOU NEED A REPAIR MANUAL

If there is a number on the lock itself, you might be able to get a key punched out.
A couple other things to do, take a 1/4 inch drill bit and drill out the lock, turn with screwdriver, should start right up, second, carefully take apart the bike, getting to the keyguard and remove the lock, then take the lock apart, get it re-keyed..

Between phone calls to danby and my neighbor, we fixed this problem. My E4 was on the left (lower chamber). If you have one on the right it is the upper chamber. The E4 is a defrost sensor that can be ordered from Danby's distributor (call Danby for the one in your area). The part and shipping were around $30.

If your E4 is on the left...

- remove the top shelves
- open the cover inside the cooler above the digital read outs (the top unscrews)
- inside is were the repacement sensor plugs in
- replace the one with the long cord
- run the sensor down the back to the lower chamber
- replace all covers and parts

If the E4 is on the right...

- remove the top shelves
- look on the right hand wall for a black plastic grate, the sensor is under this grate
- replace the sensor (simple plug and play)
- replace the racks.

Please pass this on, it was a ***** to deal with Danby and I nearly trashed the cooler out of sheer frustration.