Installing brake and tail light 1993 heritage harley davidson

Gar

• 384 Answers
• Posted on Jun 26, 2009

SOURCE: how to shut off alarm on a 2002 harley davidson heritage soft tai

I long push on the remote turns it on, 2 quick clicks turn it off.

SOURCE: 1993 Harley Davidson motorcycle (FLSTC). If I

DeJevu! I thought I answered this already. Anyway, I'll do it again. The first thing I'd try is putting new bulbs in the turn signal lights. Use the proper bulb called for in the books. This is a pretty inexpensive test.

Next, you didn't say whether or not it was both sides or just one side that was not blinking. The turn signals are controlled by the turn signal cancelling unit. I'd try to find someone that had a known good unit that would allow me to try the unit to see if that fixed the problem. I say this because the units are expensive. The last one I replaced costs about $150.

Oh yeah, on the Softail, I think the "tilt switch" located in the speedometer is involved in cancelling the turn signals as well. If the switch is stuck in the closed position, it may be cancelling the turn signal as soon as you set it. The switch is not in the circuit for the four way flashers. You'd have to look at a schematic to tell for certain. Sorry, I don't have one for a Softail.

SOURCE: harley davidson flstc heritage softail 1997

The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)

SOURCE: Tire Pressure - Harley Davidson Heritage Softtail

30 psi front
36 psi rear (single rider)
40 psi rear (dual riders)

SOURCE: I'm looking for a free

I'm sorry but I don't have a schematic for that year's Softail models. I may can send you a schematic for an FLHT or something like that. Harley wires most of their bikes about the same way for all the basic stuff. Tell me what kind of problem you are having and maybe I can help.

Thanks,
Steve