Need to no torque settings for head gasket plz and thank you
SOURCE: 93 artic cat jag head torque pattern and specs
the best place to find it is the service manual. if not avail. i usually 1, tighten it to ~10-20Nm in a 'outwards spiral' fashion, ie start tightening from centre bolts outwards. 2, spiral tighten by 1/4 turn, 3, another 1/4 turn, and 4, final 1/4 turn.
SOURCE: torque settings on front wheel yamaha 535virago
Here is a manual for the yamaha.
http://www.carlsalter.com/download.asp?fileid=089097109097104097095088086053051053046112100102
If you get one spoke right then tapping it will give a certain pitch/sound. Then you can compare it to the rest. There is a technique for lacing a spoked wheel, it would be advisable to have a professional do the work.
Here is a link to info on lacing a wheel
http://www.geocities.com/spokeanwheel/
http://www.carlsalter.com/download.asp?fileid=089097109097104097095088086053051053046112100102
SOURCE: how do you remove the seat ?? on a pw80 yamaha
There should be two bolts/ one per side on the rear side panels. The should be about 10mm and they hold the side panels and the rear of the seat to the frame. Remove those two bolts, and then slide your seat rearward, because there is a plastic tab that holds the seat to the gas tank. Installation is reverse. Slide fwd, install bolts. Good Luck.22
SOURCE: what are the torque wrench settings for a cylinder
Get in touch with your local yam dealer ,and speak to a mechanic ,they may be able to help ,or get hold of a workshop manual .
SOURCE: my yamaha pw80 wont tick over
make sure enough petrol is getting to your carb, check the fuel line going from your tank to the carb make sure it is completely free nothing bloacking it t all, nd if that does not work buy some carb cleaner :)
780 views
Usually answered in minutes!
×