SOURCE: im rebuilding my warrior
if your using the old bolts, 35 ft/lbs. if new bolts, 25 ft/lbs. that will work just fine.
SOURCE: i have a yamaha pw 80 that starts but stays revd
Check the screw on the side of the carb in the middle, just under the slide and screw it counter clockwise.If this has no effect I suggest you check the cable adjusters to make sure you have free play on the cable.
please leave fair comment if I have helped you
thanks
SOURCE: Torque spec
Head bolt torque is 32 ft.-lb. (43 nm)
Head cover bolt torque is 7 ft.-lb. (10 nm)
SOURCE: My yamaha pw 80 kickstart
Below is a diagram of the inner part of the kick starter. The spring clip shown is the problem. If it gets weak, it doesn't hold the ratchet gear as snugly as is needed. It is best to install a new clip but often you can just squeeze the clip closed a bit for a better hold to the gear.
Please rate my answer. Thanks!
Testimonial: "thanks for your help"
824 views
Usually answered in minutes!
×