How do you change the bulb on the rev counter on a yamaha ybr 125
SOURCE: Front sprocket
Hi ........... One tooth less will give you more top speed (if you can pull top revs) but will reduce accelleration. If you go for one tooth less you'll need to tighten the chain and/or remove a link. It's a trade off ............ decide what you want the bike to do.
SOURCE: What are the valve clearances of the engine of
Valve clearances are
in 0,12 mm
ex 0,15 mm
on cold engine
SOURCE: yamaha ybr 125 top speed
Hi les
Not much to start with here unfortunatly mate. A free flow muffler will help top end speed, change the factory airbox to a K&N style pod air filter, other than that, hugging the tank at top speed :) If you do change these parts, you may also need to increase the main jet size to richen up the mixture for better tuning of the motor with the better flowing parts. This bike has a top speed of 100kmp and produces 10 hp, so you may only expect to get at best less than 1 extra neddy, and perhaps another 5 km/hr.... I suggest upgrading to a bigger machine of you feel the need for speed :)
If its 125's you are into, test drive a Honda CBR 125R 6 speed fuel injected 13.4 horsepower, and good for 120km/hr
regards
robotek
SOURCE: i have a 1999 yamaha dt 125 r and the light bulb
Hi fit butcher,
The assembly of DT's speedo are all the same after 1998 models. below is a picture of a 2002 DT125/175. the assembly is the same, only that yours does not have a tachometer, yet the placement of the assembly is the same.
and here is the manual for your unit,
hope this helps,
regards,
voodoo
157 views
Usually answered in minutes!
×