SOURCE: bogging issues and clutch adjustment on 1980 RM 125
As far as your clutch adjustment ,I can't help you but the fact that the bike is older you might want to try removing the exhaust pipe at the baffel end and see if there is a difference in power ,if there is clean out your baffel and your good to go.
hope this helps
jerry
SOURCE: My yamaha fzr 250 won't start
back the valve adjustment off!! there set too tight
Testimonial: "Shims were out of spec from previous owner thanks mate i never would of checked them if you didnt mention the valve clearance"
SOURCE: my tzr125 2rk 1991 the bike splutters in every gear
gett a high preformance spark plug as i had the same problem with my bike
SOURCE: pw 50,
cover up the drilled holes this can cause problems, why was a new carb fitted? did the shop have it running?
not likely rings .
check carb for flooding and correct jet sizes.
check safety kill\start\run switch for shorts.
927 views
Usually answered in minutes!
×