When warm runs fine cold
SOURCE: Idel adjustment on fuel injected road king.\not on
Thats not totally correct. remove your air filter cover. look to the lower right side. You will see a small hole thats where the screw driver goes in to adjust your idle. Ya the dealer has a scanlizer that can also do it if u want to spend the bucks.
SOURCE: 2003 HD Road King -
If you bike is equipped with a carburetor, the idle stop screw is located at the top of the carb on the right side. Counterclockwise turn slows the idle speed.
If you bike is fuel injected, a dealer or shop will have to set the idle speed electronically.
Good Luck
Steve
SOURCE: Throttle not snapping back to idle position on
You need to take the entire throttle control assembly off the handlebars and disconnect the cables from the carburetor. Check each cable for free movement. If you have a frayed cable, you will never get it to work correctly so check the cables. Now when you go to put the assembly back together make sure you put some thin grease on the handlebar and inside the throttle sleeve before you slide it up on the handlebar. Put white lithium grease in the area where the cables connect to the throttle sleeve the bolt the two halves of the switch housing together. Slide the switch and throttle assembly all the way up on the handlebars and then back it off about an 1/8" or so. This insures that the handlebar is not rubbing on the inside of the end of the throttle grip.
Good Luck
Steve
985 views
Usually answered in minutes!
×