Posted on Jan 29, 2009

Te 450 2004 - won't start

Hello,
i'm writing from italy and i have a serious problem on my te 450.
Won't start, cold or hot the problem persist. Motor is ok.
Do you think that changing the Mikuni with the keihin fcr-mx 41 i can solve the problem?

blackbiko Feb 13, 2009

spark, fuel and air is ok. But nothing. spark, fuel and air is ok. But nothing.
Anonymous Feb 07, 2012

Try pulling choke out &/or twisting the throttle 2 or 3 times before attempting to start. Also check valve clearances.

The mikuni carbs on these things are not good. The FCR41 is a much better carb but your bike should at least start with the mikuni. Try setting the accellerator pump to come in at 1/3-1/2 throttle too.

1 Answer

Anonymous

Contributor 7 Answers
Posted on Jan 29, 2009

Anonymous

Contributor

Joined: Jan 29, 2009

Answers

Questions

Helped

6384

Points

Verify spark - fuel - air

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Bad cam shaft senser

You could have a faulty engine coolant sensor or intake air temperature sensor. Fuel injectors clogged or dirty flooding engine.
Clean fuel injectors, replace fuel filter and air filter, and see if the problem persists.
If it does ECT sensor is bad. If CMP sensor was bad, the vehicle won\'t start whether cold or hot. CKP senso and CMP sensor work together if either one fails, the vehicle won\'t start. Have the vehicle code scanned.

Read full answer

Apr 18, 2013 • 1999 Chevrolet Tracker

0helpful

1answer

Starts when cold; sputters and won't rev up when hot

is the check engine light on?

Read full answer

Feb 05, 2013 • Charging & Starting Systems for Plymouth...

0helpful

1answer

The heater won't blow hot and my a/c won't blow cold. Also no matter which speed I select for the heat/ac it stays on high, like it only has 2 speeds; high and off. Help.

Here's a link to the blower motor resistor,usually they go bad causing you not to be able to use all speeds,it's located next to blower motor,two screws may hold it on.http://www.autozone.com/autozone/parts/2002-Ford-Taurus/A-C-Heater-Blower-Motor-Resistor/_/N-jhcdrZ91tag?filterByKeyWord=blower+motor+resister&fromString=search Here's a link to the blower motor.http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?fromSearchPage=true&pageId=0996b43f8036e0aa&partName=Removal+%26+Installation&partId=0996b43f8036e0aa

Read full answer

Nov 02, 2012 • 2002 Ford Taurus

0helpful

1answer

1991 ford explorer will not turn over when hot

Have the battery tested and check the battery positive cable for corrosion. Also have a amperage draw test done on the starter motor, it is one of them. If it just clicks but won't start then the starter is defective in most cases. Have it properly diagnosed by a dealer before any parts are replaced to avoid unnecessary parts replacement

Read full answer

Aug 08, 2012 • 1991 Ford Explorer

0helpful

2answers

My stock 1985 Jeep CJ7 284 with 2bll carb will start fine when cold, but will not start once it gets hot. It is getting fuel in the carb, but no spark...engine will turn but won't catch. Once it

sometimes when the starter gets hot it won't allow the Bendix to engage properly.

Read full answer

Jul 14, 2012 • 1983 Jeep CJ7

0helpful

1answer

MY AC blows hot, it wont take a charge. a shop told me it needs a compressor so put on a new one and still won't take a charge and blows hot air

Hello again. is your heater tap actually operating? its not stuck on hot is it? just check the tap actually moves when the hot cold selector is switched.

Read full answer

Jul 06, 2012 • Oldsmobile Cutlass Supreme Cars & Trucks

0helpful

1answer

Car starts when cold and goes dead and won't start until cold again

Sounds like you might have a faulty ignition switch and ignition lock cylinder.These cars are known for the ignition switches getting hot and then they won't start.

Read full answer

Dec 30, 2011 • 1996 Pontiac Grand Am

1helpful

1answer

Hello. I have a SONY VGC-LT23e and my graphic card won`t work properly.I booted in safe mode and removed from device manager. When i try to install other driver after restart it give me a blue screen....

http://esupport.sony.com/US/perl/swu-download.pl?mdl=VGCLT23E&upd_id=3417&os_group_id=10

Read full answer

Aug 29, 2011 • Sony VAIO VGCLT23E PC Desktop

0helpful

1answer

My ac won't work, it seems that the system won't turn from hot air to cold

Sounds like a blend air door problem. Check any vacuum hoses going to the blend air door motor. It should be under dash,about in the middle close to the floor.You may need a flashlight and mirror to see it. If all looks ok, you may have a bad vacuum motor. Have a local shop check it if that is the case.

Read full answer

Jul 19, 2011 • 2007 Dodge Grand Caravan SXT Minivan

0helpful

1answer

My Yz 426F and it won`t start at all, changed the plug and it still won`t start

HELLO; Now, pull the plug out reinstall it on the ing. cable and short it out on the head while cranking the motor over ,look for a nice crisp spark. If you have one, check for fuel flow from your tank to the carb. Check that and if nothing, write back and we will go from there. GOOD LUCK.

Read full answer

Oct 01, 2009 • 2002 Yamaha YZ 426 F

Not finding what you are looking for?

View Most Popular

2004 TE 450

Motorcycles

Bad cam shaft senser

1999 Chevrolet Tracker

829 views

Ask a Question

Usually answered in minutes!

Are you a Husqvarna Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for 2004 Husqvarna TE 450? Or just drag it here!

Related Topics:

Te 450 2004 - won't start