2003 Harley Davidson FXD Dyna Super Glide Logo
A
Anonymous Posted on Feb 26, 2013

How to remove ignition switch dyna fxd - 2003 Harley Davidson FXD Dyna Super Glide

5 Related Answers

Anonymous

  • 434 Answers
  • Posted on Jul 07, 2009

SOURCE: 2005 harley dyna super glide

The baffles on stock pipes are welded in. For a louder sound, you take a long screw driver, or a drill bit and poke holes in the back of the muffler.

Ad

Anonymous

  • 216 Answers
  • Posted on Aug 07, 2009

SOURCE: Is it possible to switch out the handlebars on my

Depends.u have about 3 or 4 inches of play......if your gonna switch to ape hangers ,there will be alot of wiring to do ....... if the dimensions are close to what u got .......then it wont be required

Anonymous

  • 641 Answers
  • Posted on Oct 20, 2009

SOURCE: will the gas tank and wheels and fenders off a

I believe they could. Possibly not the fenders, but the tank, that's a probability. Check the mounts, and take some measurements of tank length on the bottom.

Testimonial: "thanks hut my bike is in a harlet storage shop for the winter and if eveything fit I was going to by the parts and have them install them during the w"

Anonymous

  • 119 Answers
  • Posted on Oct 28, 2009

SOURCE: how to change oil in 2003 HD FXD Dyna Super Glide

remove the drain plug from the oil pan, you will need either a 3/4" box wrench or a 5/8" box wrench and the drain plug will be facing forward on the the oil pan. It is easiest to remove this drain plug from under the right side of the bike. put drain plug back in after about 10 m,inutes of drain time and tighten to 18 ft. lbs. Dont forget to change the oil filter as well.

Anonymous

  • 4565 Answers
  • Posted on Oct 29, 2010

SOURCE: how do I remove the battery from a 2004 fxd dyna

I can tell you how to do it on an earllier model but Harley may have changed it on your '04. Start by removing the seat. Then just towards the rear of the bike from the battery box, there were two bolts. Loosen these bolts. Inside the frame near the battery is a "jack bolt". Loosen the bolt and it lowers the battery tray. Tighten the bolt and it raises the battery tray. I hope this helps.

Good Luck
Steve

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2004 Harley Davidson FXD Dyna Super Glide no spark

Chec connects..cud b badboot at coil..or test coil..is batt @12.6v..ign module mite b worn..buy a clymer shopbook
0helpful
1answer

2001 dyna fxd just dies while riding. Have to wait about 5 mins. before it fires back up. Can anyone help?

hi i had a simular problem with my 98 fxd turn out to be the vacuim opperated fuel tap i blocked off the vac pipe to the fuel tap and put a high flow tap in the tank all you gota remember is to turn fuel on and off but it sorted out the cutting out good luck
0helpful
1answer

How do I tighten the ignition switch on my fxd?

If your ignition switch went loose or damaged you will have to change it ,then tighten. the screw that hold the IGN switch to the frame.
0helpful
1answer

Horn doesn't blow wont crank when ignition turned on a 2003 dyna superglide

Harley horns fail. Replace the horn. If this fault has happened at the same time as engine wont crank then problem with wiring. If not then check starter relay (grey one). Also check ignition switch. Are the head lights coming on when turned on? If so the ignition switch is o/k. Connect a voltmeter to horn to check horn circuit. Accessory fuse 15 Amp supplies horn circuit and brake light and turn signal circuits so if these are working fuse o/k. Ignition/start circuit requires system relay and ECM fuse to be o/k. If fuel pump operates when run switch is activated then system relay o/k. Check start relay and circuit to start button.
0helpful
1answer

Will the dyna sportster exhaust fxd 1540 fit the dyna 2003 fxd superglide

the 96 cubic inch dyna fxd (2007 up) exhaust will not fit the 2003 dyna fxd. the sportster exhaust will not fit either.
0helpful
1answer

2007 Dyna Super Glide FXD, Do I pull the starter out without going into the Primary ? seems you do..

You need to pull primary. Then remove starter gear bolt. Disconnect battery. Then remove 2 starter allen bolts. Disconnect battery off starter and start wire. MOPAR KENNY
3helpful
1answer

How to change oil in 2003 HD FXD Dyna Super Glide

remove the drain plug from the oil pan, you will need either a 3/4" box wrench or a 5/8" box wrench and the drain plug will be facing forward on the the oil pan. It is easiest to remove this drain plug from under the right side of the bike. put drain plug back in after about 10 m,inutes of drain time and tighten to 18 ft. lbs. Dont forget to change the oil filter as well.

0helpful
1answer

Need to know how to remove.

A screw driver should do the trick, its just a switch.
1helpful
1answer

Is it possible to switch out the handlebars on my Dyna FXD w/o having to deal w/ wiring?

Depends.u have about 3 or 4 inches of play......if your gonna switch to ape hangers ,there will be alot of wiring to do ....... if the dimensions are close to what u got .......then it wont be required
Not finding what you are looking for?

1,049 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...