SOURCE: brake light stays on
hand break switch was broken (inside the wire housing) not allowing the hand break lever to deactive, therefore causing the brake system to stay on.
SOURCE: replace rer drive belt on 2005 road king
Its a 3 hr job for a trained mechanic. You really need a manual for the job. You have to remove the inner primary, pull your swing arm axle out abit..Its truly a task to replace a belt on a road King.
SOURCE: Harley Road King motor turned off
after checking the kill switch on the handle bars and the key. It could be a simple wire or even a computter problem check to see if you have spark if it even turns over, without knowing if it fuel injected or carb its hard to give an exact find or fix. If your not formiluar with the road kings working I would suggest you take it to a harley mech.
SOURCE: The tail light, turn signals, speedometer and
Yes it could be a fuse, they are located under the panel on the left side I think if not under the other panel
SOURCE: removing stock rear turn signals on 2006 Harley Davidon 1200
I have not removed the turn signals from a model this late. There may be a nut between the fender and the fender strut. You may have to remove the fender to get the turn signals off.
125 views
Usually answered in minutes!
There was a harness installed under the seat to keep the running lights on all the time because it has red signals.. Took the harness out and work fine.. I took all that of anyhow and installed an L.E.D. tail light with turn signals built in.. Love it.
×