How do i get the speedo guts out of the speedometer housing?
SOURCE: 1979 honda cbx 6 cylinder, no power at 1 coil. no
If you mean no output power, coil is bad. If you mean no input power 12v, there is a fault in the wiring. If you mean no signal from stator, wiring problem as well
SOURCE: carberator is plugged...not allowing fuel to go
remove..disasemble..clean..reasemble..install
SOURCE: cluch dieagram for a honda cbx 750
Go to( babbitts.com )you can get the picture with the part numbers.
SOURCE: how to take off a speedo drive from a honda cbx 750
if its similar to my 87cbrf1 my speedo cable routes down to the left fork and you"ll see the cable enter a black plastic piece one end having a screw, the inner cable tangs match the inner axle tangs while locked in place... you can spin the front wheel and watch the speedo react. Now to take it out all's you'll have to do is unscrew the holddown screw and pull the cable assembly back out. very easy. i just hope yours is mounted on the fork and not on the valve cover because im not too familiar with that type.hope this helps you out! can i get somefeedback.. only if it does help...thanks!
SOURCE: This is for an 1979 Honda CBX. I installed new
I PRESUME YOU THOROUGLY CLEANED THE FLOAT NEEDLE SEAT?AND INSPECTED THE NEEDLES FOR LIKENESS COMPARED TO THE OLD ONES, SOMETIMES YOU HAVE TO IGNORE THE FACTORY SETTINGS PLACE THE CARBS ON THE BENCH WITH A FUEL SUPPLY CONNECTED AND ADDJUST EACH FLOAT UNTILL THE LEVEL OF FUEL IS BELOW THE OVERFLOW TUBE ALLOWING ENOUGH ROOM FOR THE FLOATS SO THAT THE LEVEL STILL LYES BELOW THE TUBE WHEN FULLY ASSEMBLED, COMPLETE THIS TEST BEFORE FIXING THEM TO THE BIKE, WHEN YOU ARE HAPPY REPLACE THEM BACK ON THE BIKE,
PS IS THE NEEDLE SEAT AVAILIBLE SEPERATLY MAYBE WORTH INVESTING INSOME NEW 1S IF THEY DO
YOU COULD HAVE THE CARBS ULTRASONICALY CLEANED
236 views
Usually answered in minutes!
×