Have to change belt on q-link sierra 150 scooter. how does the skins come of on the left side where the belt drive is?

this could mean the scooter is not in drive try the free wheel lever first.

sounds to me that your belt is slipping
try changing your belt
different manufacturers all have different prices
but most Chinese scooters all have the same gy engine and drive gear
so shop around and find the cheapest

try and get your hand under the left side rear finder and reach for the locking cable and pull the cable down that should release the locking device.

Hi Gary,
Checkout this Tank Touring Manual.

Hope this helps.Thanks!

The engine probably stopped because the broken belt wrapped itself around the variator. Highly likely it did no engine damage because that would have been a slow stop, not abrupt. Just replace the belt and start her up.

To change the final drive belt on your Fatboy, first disconnect the battery. You have to drain the primary and remove the cover. Take the engine sprocket nut loose and remove the plate in the center of the clutch assembly. Remove the mainshaft nut that holds the clutch assembly on. This nut has LEFT HANDED THREADS. Then, remove the starter jackshaft. Go the right side of the bike and remove the exhaust system so that you can remove the starter. Then take the inner primary cover off. You may have to remove the front belt drive pulley. Since you're in this far, you may as well remove the pulley if you have the proper tools and replace all the transmission seals behind it. Then, remove the rear wheel and the swingarm. Do not bend the new final drive belt into a radius any tighter than about four inches or you may damage the cords inside the belt. You will need a torque wrench that is capable of applying at least 150 foot pounds of torque to the engine sprocket nut and torqe 60-80 pounds in the LEFT HANDED DIRECTION for the clutch assembly. The front belt drive pulley torques to 150-165 foot pounds as is also LEFT HANDED THREADS and you'll need a "belt pulley locking device" to hold it while you take the large nut off and put it back on. If you plan on doing this job, I would advise the purchase of a service manual as sometimes a picture is worth a thousand words.

Good Luck
Steve

Usually just a bad connection. Clean the side panel pin on the 'front' of the panel and the hole in the frame. Check also that your rear pin's rubber sleeve is in good condition.

1. http://www.livefromhawaii.com/geelyscooters/

2.
http://www.livefromhawaii.com/geelyscooters/OwnersManual.pdf

Good luck!!