I'm hoping someone can help with the following,
I have just installed a Triumph approved datatool S4 alarm alarm which was straight forward except for one aspect and that was the installation of the ignition connector. The problem is that i cannot locate the 8-way connector mentioned in the instructions which is where i'm required to cut the igniton wire either side of the 8 way connector, to be honest i'm not sure what this connector does but i'm sure it is to be fitted. So if anyone can identify where i'm to find the 8 way connector then that would be much appreciated,
Regards
Should e connected to left rear blinker plug under your seat
You could try T595.net ... they have lots of smart guys with answers to stuff like this ... at a guess you are looking for a bundle of black wires that goes to a socket/plug under the seat ... the plug will have one or two loops of wire making the ignition circuit ...
If you had a factory alarm fitted it would be plugged directly into this connector
356 views
Usually answered in minutes!
×