What is a "card" on a PW50? I have one here and have no idea what part you could mean. My guess with the throttle is that you have the cable way too tight. Check that first - it is quite touchy, since the idel is also st with the cable tension on some earlier models.
SOURCE: pw50 problems stating bike
hey there matey,, just to run a few things with,, have u taken the spark plug out and cleaned it up,,try a new plug 1st,, to be sure, or if u have a new plug,, take out the spark plug place it back in its cap and rest it on the cylinder head and either elec start it or kick it over and make sure u have a spark ,, if all is ok on the above,, then turn to fuel and carburetta, make sure fuel is gettin to the carb 1st,, but u say u do eventually gettin it goin ,,then theres a blockage in jets ,,undu the bottom of the carb clean out the bowl, ,in the carb u will see a brass jet, un screw that and the needle guide that the jets screwed in to and using a pin or needle,poke the small hole clean so u can see light threw them,, bung it all back together and pray,, if no joy il get back to ,, ok m8, enjoy
SOURCE: i have a yamaha pw50, it runs slow when cold &
Most likely a combination of sparkplug heat range (type of plug) and jetting, needle or air mixture settings in the carburetor. Assuming good condition of air filter and operation of the choke plunger. Are you using the correct octane fuel and fuel/oil ratio? Give the plug a clean and emery the spark contacts, set gap at 0.7mm., ideally take the plug to a Yammy dealer and check for correct range for your bike in the area where you ride.
Best to have a range of spare clean plugs handy for wet or hot days etc.
The jetting maybe dirty or wrong size too. In the meantime move the throttle needle clip down one notch. Refer to the site below for a diagram of the carburetor parts. Cheers.
http://www.cmsnl.com/yamaha-pw50r-2003_model11163/partslist/A-09.html
SOURCE: Pw50 starts first time everytime but will not
PW have the stop\start\run switch and will not rev in the start position, there may be a problem in this switch, wire, or the ignition box which controlls this.
The small 50s can also build up carbon in the exhaust port, or the exit end of the muffler.
They also need the original air filter and cover (dont know why, but they wont rev without it).
I realize you may have checked some of these, but not much else goes wrong
311 views
Usually answered in minutes!
×