Can you show picture or diagram of engine oil drain plug location for 2000 harley davidson heritage softail

SOURCE: oil drain plug

oil tank

SOURCE: oil drain plug

its not a plug its a hose look under the tank on the pipe side, look for the hose thats goes to the bottom frame rail (tube) thats the drain hopes this helps

SOURCE: oil drain plug

Hi
It is located on the right side just under the oil tank ; if you follow the rudder hose that exits the rear right side of your oil tank it leads to the bottom of the frame under this is the oil plug. This hose has a plug clamped to the end of it or stuck into a prug that is welded to the frame.
After this unclamp and pull the plug to make sure that you have the dipstick out before pulling it loose.

Please do rate the solution as "FixYa" if found useful and revert for further assistance.
Thanks Rylee

SOURCE: oil drain plug

Its at the back of crank box right hand side of bike attached to bottom of frame in a sprung clamp just before the softtail swingarm- black hose with a plug and hose clip

SOURCE: harley davidson flstc heritage softail 1997

The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)