1990 Yamaha FZR 1000 Logo

Related Topics:

John Xintaras Posted on May 11, 2009

XV1100 virago ...sputtering, dying...NOT FZR!!

Just had the gas tank painted, 1990 XV110 virago...went to wash bike...less than a mile from home, started to sputter, then died. took a while to get back started, did the same thing. Finally got it started, back home...let it sit running for about 15 mins...lots of backefire when revved, but didnt sputter. turned off...tried again about 3 hrs later...no sputter, but backfire still. any ideas???

1 Answer

lapum0nz

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 18 Answers
  • Posted on May 11, 2009
lapum0nz
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: May 11, 2009
Answers
18
Questions
0
Helped
11722
Points
26

1 maybe there is a diaghfram tear at your carb only 1 is funtioning and 1 block engine is running but under power
2.check your fuel line from tank to fuel filter then pump then carb
probally there is a debrie stuck in the pipe line or in your tank

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Need turn signal wiring diagram for a 96 100 virago

Virago Tips and Tricks - PBase.com

www.pbase.com/iamflagman/virago_tips
'96 XV1100 VIAGRO CORBIN SEAT MAC EXHAUST LEATHERLIKE BAGS KJS ...HOME MADE TURN SIGNAL RELOCATING BRACKET AND WIRING ..... hi. im in need of a diagram for how to fit a 1997 virago 125 carb bought bike in bits but .... For less than $100 you can have a steel manifold to mount one of your stock ...

Testing and replacing the turn signal relay on a Honda ...

? 5:04
www.youtube.com/watch?v=I7lWBObymg0
Oct 15, 2013 - Uploaded by funbro1 Testing and replacing the turn signal relay on a Honda shadow100 Sabre. ... When I tested my blinker lights by jumping thewires I get a bright blinker .... i got a 96 shadow...im replacing theturn signals with LEDS, when i hook ... website and they usually have a parts diagram for all bikes on Micro Fiche.
Oct 16, 2015 • Motorcycles
0helpful
1answer

My fzr 1000 sputters, backfires, and looses power .... oh and dies every now and again! what should I do?

most likely a fuel issue, clean carbs, check fuel filters( there are often filters inside the tank on the fuel pickup tubes) check vacuum operated fuel tap
1helpful
1answer

How do I remove the fuel tank from my XV1100?

you must first drain it and put it in the clean container then unbolt nut where the fuel is lock on..
0helpful
1answer

1990 FZR 600 - Battery problems? drainage?

this is yours jarnater or regulater problem same problem to me i have fzrr 400 but i install a new regulater and then i solve my problem
1helpful
1answer

Bike started to sputter and lose power fuel

This sounds like water in the gas. Condensation in the gas tank makes it's way into the float bowl and after enough accumulates the bike dies because water just doesn't burn like gas. Drain the carbs and then let them fill up again. The good thing is that the cost to eliminate this as a problem is zero.
0helpful
1answer

1990 virago 535 starts and runs great for about 3 or 4 miles

Pull the float bowl caps off the carbs and then spray carb cleaner into the main jet and all other accessible ports on the carbs. Chances are there is a build up of water condensation in the carbs.

ffa79c2.png
2helpful
1answer

2007 yamaha virago won't start - replaced spark plugs and emptied gas tank and filled with new gas. it turns over - it has spark (fire) but won't start. Bike had been garaged for six months with full tank...

it's not that your not gettin gas it's that the gas is not getting thru the carbs to the engine. your bike will probably start w/choke on and then die, your jets are clogged and happens to most bikes that are stored w/gas in the carbs.,,,clean them if you know how or take it to a trusted mech...good luck to you...Tim
Not finding what you are looking for?

725 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...