SOURCE: 1979 honda cbx 6 cylinder, no power at 1 coil. no
If you mean no output power, coil is bad. If you mean no input power 12v, there is a fault in the wiring. If you mean no signal from stator, wiring problem as well
SOURCE: carberator is plugged...not allowing fuel to go
remove..disasemble..clean..reasemble..install
SOURCE: cluch dieagram for a honda cbx 750
Go to( babbitts.com )you can get the picture with the part numbers.
SOURCE: This is for an 1979 Honda CBX. I installed new
I PRESUME YOU THOROUGLY CLEANED THE FLOAT NEEDLE SEAT?AND INSPECTED THE NEEDLES FOR LIKENESS COMPARED TO THE OLD ONES, SOMETIMES YOU HAVE TO IGNORE THE FACTORY SETTINGS PLACE THE CARBS ON THE BENCH WITH A FUEL SUPPLY CONNECTED AND ADDJUST EACH FLOAT UNTILL THE LEVEL OF FUEL IS BELOW THE OVERFLOW TUBE ALLOWING ENOUGH ROOM FOR THE FLOATS SO THAT THE LEVEL STILL LYES BELOW THE TUBE WHEN FULLY ASSEMBLED, COMPLETE THIS TEST BEFORE FIXING THEM TO THE BIKE, WHEN YOU ARE HAPPY REPLACE THEM BACK ON THE BIKE,
PS IS THE NEEDLE SEAT AVAILIBLE SEPERATLY MAYBE WORTH INVESTING INSOME NEW 1S IF THEY DO
YOU COULD HAVE THE CARBS ULTRASONICALY CLEANED
SOURCE: hi i have a 1975
Move the clip on the jet needle lower on the needle. This will help with the flat spot by giving fuel earlier. The black smoke is a rich fuel mixture. Check to see that the carb kit had stock jet sizes. Be sure to synchronize the carb slides so they both begin to lift at the same exact moment.
143 views
Usually answered in minutes!
×