Wont start hi my bike wont start i was on it yesturday and it just cut out for no reason been tryin to fine the problem but cant can u help me please

You actually may have two problems. First, if you have a spark from a coil, find out why. May be a bad or loose connection. when coils get hot their resistance increases. A leak or bad connection will show up quicker when hot. If the spark comes from the body of the coil, replace it.
Second, your starter may be breaking down when hot. Check the brushes and coils in the starter motor. The same discussion about loose connections also will apply to the starter.
good luck

you need a high speed un-interrupted internet connection to complete installation of all 117 updated

Hi,
That looks like a REED VALVE leak.
If your 2 stroke kept coming out from the carb air intake and as you say that sometimes a back fire in the exhaust.

Check these....

• Reed valve
• Crank oil seal ( there might be air leak in the block )
• Exhaust pipe ( might be already blocked )

Hope that helps you out!

Hi,
It is a long process. When you click on forgot password, it will ask you number of questions and you'll have to recognize some of your friends and more. You have to answer them all correctly else it won't allow you to reset password. This is very important for your account security so kindly do it.
Good Luck!

check the cooling system may be raideater blocked

start with the battery and check the fuses around .
did you check as well that your cut off switch is not damaged and may earth itself .
power issue s like this one you will have to work from the battery and work your way away from it .
check all wiring for bare wires that may contact the frame .
What you may have to do also is really look at where the bike has got damage and look around for cut wires or damage items .

check your fuel pump power and pressure.sounds like fuel delivery problem

Eventually it won't start at all if you keep redlining her like that. My advice to you is get a faster bike.

You have a dead short somewhere,Just start tracing wires for the ignition first.

Start with the switch and work your way back.