Driveshaft problem , can't get it back in after we take it out when we teke the back wheel of
Separate the final drive from the DS then install the DS back on the out put splines of the trans, and reinstall the final drive, you can gain partial access to the u-joint end by removing the stowage box and pulling back the rubber boot and use a small screw drive to help align the splines.
To remove the rear wheel, just lift the bike, remove the brake support arm, and remove the axle nut and axle, remember to note the spacers and what side each came from (not interchangeable) the wheel will move to the brake side enough to be removed from the final drive.
When reinstalled torque the axle nut to 81 lbft
624 views
Usually answered in minutes!
×