Yamaha ybr 125 error codes

SOURCE: Front sprocket

Hi ........... One tooth less will give you more top speed (if you can pull top revs) but will reduce accelleration. If you go for one tooth less you'll need to tighten the chain and/or remove a link. It's a trade off ............ decide what you want the bike to do.

SOURCE: What are the valve clearances of the engine of

Valve clearances are
in 0,12 mm
ex 0,15 mm
on cold engine

SOURCE: yamaha ybr 125 top speed

Hi les
Not much to start with here unfortunatly mate. A free flow muffler will help top end speed, change the factory airbox to a K&N style pod air filter, other than that, hugging the tank at top speed :) If you do change these parts, you may also need to increase the main jet size to richen up the mixture for better tuning of the motor with the better flowing parts. This bike has a top speed of 100kmp and produces 10 hp, so you may only expect to get at best less than 1 extra neddy, and perhaps another 5 km/hr.... I suggest upgrading to a bigger machine of you feel the need for speed :)
If its 125's you are into, test drive a Honda CBR 125R 6 speed fuel injected 13.4 horsepower, and good for 120km/hr
regards robotek

SOURCE: fork oil capacity

medium fork oil - 150 mls in each leg

SOURCE: why does my engine cut off?

Possible reasons are;

1. Water condensation in the gas tank has partially filled the carb float bowl. Bikes don't run well on water. Remove the drain plug on the float bowl to drain the bowl.
2. Install a new spark plug to eliminate possible carbon shorting.
3. Check the side-stand kill switch. Broken or out of adjustment it can intermittently kill the engine.
4. A loose or dirty plug in connection on the power wire to the coil.
5. Bad kill switch on the handlebars.
6. An abraded kill switch wire or power wire.