Brake light stays on
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: brake light
front brake lever not depressing brake light button. inside throttle housing or I had a guy the other day thought brake light was stuck on (found burnt fillament brake light)
SOURCE: HOW TO CHANGE REAR BRAKE LIGHT SWITCH ON A HARLEY
To change the switch, first unplug the wires at the switch. Screw the old switch out and install the new switch into the tee connector. Do not depress either brake lever while the switch is out. Tighten the switch and reconnect the wires.
Usually you don't have to bleed any air out of the brake system but check the rear brakes for proper operaion. If the rear brake pedal goes too far down, bleed the brakes at the rear caliper. Make sure you don't run the rear brake master cylinder dry while bleeding the rear brake. Use only the approved type of brake fluid, do not mix the different types of fluid. Make sure the rear brakes are working properly before riding the bike.
SOURCE: rear brake pad installation 2006 flhx harley
Do Not remove wheel.............push the pads back and remove the two pins.
Note there is a inner and outer pad on assembly, have a look at the new pads they are different
SOURCE: 2006 Harley Davidson street glide brake light
Try loosening the bolts holding the front master cylinder on the handlebars. Slide the master cylinder down as close as possible to the right handlebar switch housing. If this doesn't work, the front brake light switch is probably bad and needs to be replaced in the right switch housing.
Good luck
Steve
193 views
Usually answered in minutes!
×