2008 model year. changed PIN number to clear system. No default codes come up.
Have you used the new PIN to manually disable the security system?
Do not turn handlebars, straddle seat or lift motorcycle off the jiffy stand. During a PIN disarm, if the security system detects motorcycle motion the system will activate.
Turn ignition to IGN.
If armed, the odometer window display will read: ENTER PIN and the security lamp will be flashing at a fast rate. The headlight will not be on.
Press and release the left turn signal switch.
In the odometer window, a flashing 1 will appear.
Increment the digit by tapping the left turn signal until the odometer window displays the first digit of the PIN.
The first digit in the odometer will be the first digit in the PIN.
Press right turn switch 1 time.
The first digit is stored and the next digit will flash.
Increment the second digit using the left turn switch until the digit reaches the second digit of the PIN.
The second digit in the odometer will be the second digit in the PIN.
Press right turn switch 1 time.
The second digit is stored and the next dash will flash.
Increment the third digit using the left turn switch until it reaches the third digit of the PIN.
The third digit in the odometer will be the third digit in the PIN.
Press right turn switch 1 time.
The third digit is stored and the next dash will flash.
Increment the fourth digit using the left turn switch until it reaches the fourth digit of the PIN.
The fourth digit in the odometer will be the fourth digit in the PIN.
Press right turn switch 1 time.
The fourth digit is stored and the next dash will flash.
Increment the fifth digit using the left turn switch until it reaches the fifth digit of the PIN.
The fifth digit in the odometer will be the fifth digit in the PIN.
Press right turn switch 1 time.
The fifth digit is stored. The security system indicator lamp stops blinking.
Smart Security System is disarmed.
If a mistake is made while entering PIN, turn the ignition Switch to OFF before entering the last digit and then start the procedure from the beginning.
If the procedure fails to disarm the security system, wait two minutes before attempting another PIN disarm.
The security system will remain disarmed until the ignition is turned to OFF.
SOURCE: Cannot start my 2004 Sportster 1200 Custom due to security system
Check the battery, try jump starting it with another battery. If the battery voltage drops too low, i believe the alarm default is to disble the bike. (Greasy little criminals will cut battery cables to disarm the alarm) so although you may have enough power to operate the lights and alarm, it may be droppoing too low to start.
SOURCE: Electrical issue on 2005 Sportster 883
some thing similar happened to me and it was the regulator i took it in and it's been fine ever since
SOURCE: I have a 2008 Ultra
Sounds like a security system to me. I have no idea as to what to do about it. it depends on the type of system you have.
Good Luck
steve
SOURCE: Turn signals, horn and brake
Not sure of the year of your bike, but if you have an aftermarket alarm system, it is related to the alarm system itself or a bad relay in the circuit.
282 views
Usually answered in minutes!
×